Chery B11. Manual — part 149
Chery Eastar Service Manual Body Dimension and Accessories
47
Door Limiter
Disassembly and Assembly
l. Remove the connecting bolts between the
limiter and B column.
2. Unscrew the two fixing bolts between the
limiter and door.
3. Remove the stopper code from the door
cavity.
Assemble in the reverse order of disassembly.
Assembling requirements: The tightening torque of bolt shall be 7.2±0.7 N·m. the torque of bolt
mounted on the door post shall be 25±3 N·m, and the torque of bolt mounted on the door shall be 9±1
N·m. The door stopper shall operate flexibly and reliably, without being clamped, seized and etc. The
lubricating grease shall be applied between the tower rod and slide block of the limiter.
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
48
Chapter Six Windshield
Parts
Auxiliary grab handle
Roof lining
Front roof lining
Sun visor
Lighting
lamp
Mirror
Sun visor
Interior
rear-view mirror
Middle sun visor
Bearer
Front post trim
High mount
brake lamp
Speaker
mesh
Storage box
trim plate
Middle post
trim
Roof side trim
Rear seat
backrest
Rear door frame plate
Front door frame plate
Rear seat cushion
Rear seat lighting lamp
Front seat
Rear seat
side trim
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
49
Parts (continued)
Engine hood
Outside panel strip
Heater hose
Outside panel strip
Upper panel strip
Windshield
Door weather seal
Wiper arm
Stopper
Clamping
Door weather seal
Hood louver boards
Hood louver boards weather seal
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
50
Disassembly of Windshield
Disassemble the Windshield
l. In the vehicle, pass a piano wire through the gap
between the body and windshield.
2. Apply the wood blocks or equivalents to seize up the
both ends of piano wire.
Hint: The adhesive tape is applied in the outside of piano
wire to avoid damaging the external surface of
windshield.
WARNING:
When detaching the glass, take care not to damage the
painted surface and outside/inside trims. To void scuffing
the instrument panel when disassembling the windshield,
a plastic sheet can be placed between the piano wire and
the instrument panel.
Pull the piano wire along the surrounding of windshield,
cut off the adhesive, and remove the windshield.
WARNING: When cutting off the adhesive of windshield,
leave as much adhesive on the body as possible.
Assemble in the reverse order of disassembly.
Assembly of Windshield
Do not touch the surface of windshield after
cleaning
l. Apply a knife to remove the coarse parts from the
body.
Hint: Leave as much adhesive on the body as possible.
2. Apply a cloth soaked in cleaning solution to clean the
cutting surface of adhesive.
Hint: Even though all adhesives are removed, the surface
of body shall be cleaned.
Detach the Stopper:
Apply a knife to detach the stopper.
Adhesive
Stopper
Piano wire
Adhesive
PDF created with pdfFactory Pro trial version
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст