Chery Tiggo T11 LHD. Manual — part 45
T11 Service Manual Suspension and Steering
Removal and Installation of Steering System
Steering Column
1) Remove the steering wheel (Refer to the section of accessory removal and installation).
2) Remove the left lower shield (Refer to the section of accessory removal and installation).
3) Loosen the upper fixing bolt of steering
column.
4) Loosen the lower fixing bolt of steering
column.
5) Loosen the intermediate shaft lock nut that
connects to the steering gear.
Fixing Point
Lower Fixing Bolt
T11 Service Manual Suspension and Steering
6) Remove the steering upper and lower shield.
7) Remove the steering column assembly.
8) The mounting of steering column shall be performed in accordance with the inverted sequence
of removal.
Torque:
Steering wheel nut :27~33N.m
Upper fixing bolt: 25~30N.m
Intermediate shaft and steering gear input shaft: 25~30N.m
Steering Gear
1) Drain the power steering liquid.
a) Lift the vehicle to make the wheel off the ground.
b) Dismount the power steering oil-return hose from power steering liquid reservoir.
c) Put oil-return hose into a tank than can contain the discharged steering liquid.
d) Start the engine, and perform idle running.
e) Turn the steering wheel come-and-go to the limit position.
Caution: never keep still when bringing down, otherwise hydraulic system will be damaged.
f) Ensure the steering liquid is completely drained, and then stop the engine.
2) Elevate the vehicle.
3) Loosen the upper and lower jacket of steering gear.
4) Loosen the high and low-pressure oil pipe.
T11 Service Manual Suspension and Steering
5) Loosen the left side fixing bolt of steering
gear.
6) Loosen the right side fixing bolt of steering
gear.
7) Loosen the bolt that connects right and left
steering knuckle tie rod and the knuckle.
8) Remove the steering gear assembly.
9) The mounting of steering gear shall be performed in accordance with the inverted sequence of
removal.
Torque:
Mounting bolt of power steering gear: 75~85N.m
The connection between steering tie rod and the knuckle: 45N.m
Left Fixing Bolt
Right Fixing
Bolts
T11 Service Manual Suspension and Steering
Steering Oil Pump
1) Drain the power steering liquid
2) Loosen the oil pump belt.
a) Loosen the fixing bolt of tension pulley
b)
Turn
the
adjusting
bolt
counterclockwise to loosen the belt.
4) Loosen the two fixing bolts under the
pulley.
5) Loosen the fixing bolt at opposite side.
6) Remove the oil pump.
7) The mounting of steering oil pump shall be performed in accordance with the inverted sequence
of removal.
Torque:
Tightening of steering oil pump: 20~30N.m
Lock nut of tension pulley: 32~38N.m
Adjusting Nut
Fixing Nut
Fixing Bolts
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст