Chery Tiggo T11 LHD. Manual — part 93

T11 Service Manual Transmission

114

Section Ⅵ Intermediate Gear for Reverse Gear

1. Disassembly and Assembly

a. Apply the gear oil (75W-90) when assembling

b. Lubricate all interior components

1.

Idler shaft

2.

Needle bearing-idler

3.

Reverse gear idler

4.

Thrust plate-idler

5.

Snap ring-idler thrust plate

2. Inspection

1) Needle Bearing

(1) Assemble the shaft together with the gear, and then examine they can slide smoothly

without sagging or noise.

(2) Examine there is no deformation in the bearing cage.

T11 Service Manual Transmission

115

Section Ⅶ Gear Shifting Mechanism

1. Gear shifting mechanism housing

2. Air guide pipe

3. Air guide pipe cap

4. Bearing-gear shifting mechanism

5. Gear shifting shaft

6. Front neutral position return spring assembly

7. Interlocking plate assembly

8. Gear shifting finger

9. Pin GB879 5X22

10. Pin GB879 6X26

11. Reverse gear locking mechanism assembly

12. Rear neutral position return spring

13. Baffle-rear neutral position return spring

14. Plain washer-interlocking plate limit stop screw

15. Limit stop screw-interlocking plate

16. Retainer plate-reverse gear locking mechanism

17. Washer GB938

18. Bolt GB5783 M8X22

19. Oil seal-gear shifting shaft

20. Gear selecting arm support assembly

21. Bolt GB5783 M8X20

22. Lower dust cap-gear selecting arm

23. Lower bush-gear selecting arm

24. Gear selecting arm assembly

25. Upper bush-gear selecting arm

26. Plain washer-gear selecting arm nut

27. Nut GB6170 M8

28. Upper dust cap-gear selecting arm

29. Dust cap-gear shifting shaft oil seal

30. Gear shifting drive slider

31. Gear shifting arm assembly

32. Reverse lamp switch assembly

T11 Service Manual Transmission

116

1. Disassembly

Disassembly of lock pin:

Punch out the lock pin in this direction shown

in the left figure.

2. Assembly

1) Installation of the needle bearing

Press in the needle bearing to the dimension

shown in the left figure. In this case, the side

surface with the stamped model shall be in

the side of controller housing.

2) Installation of oil seal

Apply the transmission oil on the oil seal lip.

The transmission oil: 75W-90

3) Installation of vent

(1) Apply the sealants on the surface of the

inserted part.

Pin

Shifting
finger

Gear shifting
mechanism
housing

Bearing-gear
shifting
mechanism

Side with
stamped model

T11 Service Manual Transmission

117

4) Installation of spring pin

5) Installation of spring pin

Punch out the lock pin in this direction shown

in the left figure.

6) Installation of lock pin

Installation direction

Gap

Pin

Pin GB879 5X22

Shifting finger

Reverse gear locking
mechanism assembly

Gear shifting shaft

Pin GB879 6X26