Chery Tiggo T11 LHD. Manual — part 86
Service Manual for Chery·Tiggo(T11) Engine Section
Installation Notice
O-shape seal installation
(1)Make seal ring wet to install it easily.
Caution:
There must be no engine oil or lubricate grease
on seal ring.
Daub thermostat shell with sealant
Specific sealant:
Component of Mitsubishi brand 3M ATD
or equivalent.
Note:
(1) Thermostat
shell
should
be
installed
immediately when the sealant is still wet (in 15
minutes).
(2) Don't daub oil on the sealed part in about 1
hour after installation.
Daub engine coolant induction plug with sealant
Specific sealant:
3M ATD or equivalent
Daub engine coolant temperature sensor with
sealant
Specific sealant:
3M
ATD
nut
fastening
or
equivalent
Hose
O-shape seal ring
Sealant of diameter
3mm shall be piled out
Service Manual for Chery·Tiggo(T11) Engine Section
T11 Service Manual Transmission
88
Chapter Ⅱ
QR523 Transmission Service Manual
T11 Service Manual Transmission
89
Section Ⅰ Special Service Tools
Tool
Symbol
Name
Application
MB990926
Installer Connector
To install the oil seal of input
shaft
MB990934
Installer Connector
To install the outer race of
bearing
MB990935
Installer Connector
To install the outer race of
front/rear bearing of the
differential
MB990938
Handle
Apply this handle together with
the installer connector
MB998325
Oil seal/differential
installer
To install the oil seal of
differential
MB998346
Bearing outer race
detacher
To uninstall the outer race of
bearing
MB998772
Valve spring
compressor
To uninstall the outer race of
bearing
MB998801
Bearing detacher
To install/uninstall the gears,
bearings and sleeves
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст