Chery Tiggo T11 LHD. Manual — part 85
Maintenance Manual for Chery·Oriental Son
Engine Section
with oil in an hour or so
after installation.
(3) Confirm the bolt length and their
installation locations are a little different.
Drain plug cushion installation
Install drain plug cushion according to the
direction as shown.
Caution:
The incorrect installation direction may
result in oil leakage.
Oil cleaner installation
(1) Make installation surface of oil cleaner
bracket clean.
(2) Daub engine oil on O-shape ring of oil
cleaner.
(3) Screw on oil cleaner. When the O-shape
ring reaches installation surface, screw
3/4 cycle further. (Tighten torque:
1.4kg.m)
Check
Front cover
(1) Check if oil hole is jammed. If necessary,
clear it up.
(2) Check if there is abrasion, damnification
or sinter on left balance axle front bearing.
If necessary, replace front cover.
(3) Check if there is crack or other
damnification. If any, replace front cover
component.
Oil seal
Drain plug
cushion
Oil pan side
Bracket side
8mm-length bolt
Crankshaft pulley side
Oil pan bottom
view
Maintenance Manual for Chery·Oriental Son
Engine Section
(1) Check if there is abrasion or
damnification on oil seal lip. If
necessary, replace oil seal.
(2) Check if there is deterioration
on oil seal lip. If necessary,
replace oil seal.
Balance axle
(1) Check if oil hole is jammed.
(2) Check if there is sinter, damnification or
interposition of bearing.
If any badness,
replace balance axle, bearing or front
cover component.
Oil pump
(1) Install oil pump gear on front cover and
then screw on the gear. Check if it can
rotate smoothly and is tightened.
(2) Ensure there is no
ridge shape abrasion
on
the contact surface of front cover and oil
pump cover gear surface.
(3) Check side clearance.
Standard value:
Drive gear 0.08-0.14mm
Driven gear 0.06-0.12mm
Maintenance Manual for Chery·Oriental Son
Engine Section
Service Manual for Chery·Tiggo(T11) Engine Section
Chapter 6 Cooling System
Intake Manifold, Water Pump
Remove Steps:
1. Water soft tube
2. Water soft tube
3. Engine coolant temperature sensor
4. Engine coolant induction plug
5. Inflow tube joint
6. Thermostat
7. Thermostat shell
8. Inflow Tube
9. O-shape seal ring
10. Water pump
11. Water pump seal ring
12. Oil gauge
13. Oil gauge duct
14. O-shape seal ring
15. Manifold bracket
16. Intake manifold
17. Manifold gasket
18. Engine flying ring
20N.m
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст