Chery Tiggo T11 LHD. Manual — part 9
Chery T11 Service Manual
Body and Accessories
-34-
11. Removal and Installation of High-mounted Stop Lamp
1) Dismantle the shield for high-mounted stop
lamp.
2) Dismantle the fixing screw.
3) Remove the high-mounted stop lamp.
4) Install in the reversed sequence.
Torque:
Fixing of tapping screw 3±0.5Nm
12. Front Ceiling Lamp
ⅰ Removal and Installation of Front Ceiling Lamp
1) Open the glasses box.
2) Loosen the tapping screw by cross
screwdriver.
Tapping Screw
Chery T11 Service Manual
Body and Accessories
-35-
3) Remove the front ceiling lamp gently, and
unplug the wiring harness.
4) Install in the reversed sequence.
Torque: Fixing of tapping screw 3±0.5Nm
ⅱ Replacement of front ceiling lamp bulb
1) Prize up the enclosure by flat screwdriver.
2) Remove the used bulb and replace it with a
new bulb.
13. Removal and Installation of Middle Ceiling Lamp
1) Insert a flat screwdriver between the
enclosure and lamp cover, and prize up the
lamp cover with care.
2) Loosen the fixing screw.
3) Remove the ceiling lamp.
4) Install in the reversed sequence.
Torque:
Fixing of tapping screw 3±0.5Nm
Fixing Point
Enclosure
Chery T11 Service Manual
Body and Accessories
-36-
14. Rear Ceiling Lamp
Please refer to the dismantle and assembly procedure of middle ceiling lamp for the rear ceiling
lamp .
Ⅵ Replacement of Windscreen
1. Replacement of Front Windscreen
Dismantle Procedure
1) Remove the top fillet of windscreen, and
cut the fillet as shown in the figure.
Note: Pay attention not to damage the body.
2) Remove the windscreen.
a. Lead a wire string toward outside
between the body and the glass.
b. Bind both ends of the string with
wooden block or similar stuff.
Hint: Apply an adhesive tape at the outside
surface to prevent any scratch.
Note:
When detach the glass, please pay
attention not to damage the paint or
any decorative part inside and
outside.
In order to prevent any scratch to the
instrument
panel
during
the
disassembly, a piece of plastic can be
placed in between the wire string and
instrument panel.
c. Pull the string around the glass to cut
off F adhesive, and to remove the
glass.
Note: While cutting the bond of the glass,
please leave as much as adhesive on the
body.
Adhesive
Wire String
Chery T11 Service Manual
Body and Accessories
-37-
Installation Procedure
1) Preparations:
a. Don’t touch the surface after cleaning.
b. Cut off any coarse on the body.
Hint: Leave as much as adhesive on the body.
c. Clean the cutting surface of adhesive
with
clean
cloth
soaked
with
detergent.
Hint: The vehicle surface shall be cleaned even
all adhesives are removed.
2) Remove the block.
Remove the block by knife.
3) Clean the dismantled windscreen.
a. Remove any adhesive on the glass by
scraper.
b. Clean the glass with detergent
Note: Please do not touch the glass after
cleaning.
4) Replace the nip in case of necessary.
a. Remove the block by knife.
b. Remove the used nip.
c. Replace it with a new one.
5) Positioning of the glass.
a. Place the glass to the right position.
b. Mark both the glass and the body.
c. Remove the glass.
Block
Adhesive
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст