Chery Tiggo T11 LHD. Manual — part 8
Chery T11 Service Manual
Body and Accessories
-30-
d. Dismantle the three fixing bolts at the
top of front bumper.
e. Remove the bumper with attention to
the top clips at both sides. Unplug the
wiring harness for the two foglamps in
front.
Note: Please don’t overexert while taking out
the wiring harness as well as plug for the
foglamp.
2) Dismantle front foglamp from the bumper.
Dismantle the three nuts as shown by the
arrow by open wrench, and remove the
foglamp assembly from the front of the
bumper.
3) Install in the reversed sequence.
Torque:
Fixing of front foglamp 2.0±0.2 Nm
Q32006 (3 pcs)
7. Replacement of Fog Lamp Bulb
1) Hold the backseat of the bulb and spin it
out in counterclockwise.
2) Install the new bulb in clockwise.
3) Install the new bulb of foglamp.
Fixing Nut
Chery T11 Service Manual
Body and Accessories
-31-
8. Taillamp
1) Position of each bulb in the taillamp assembly.
2) Removal and Installation
(1) Open the back door.
(2) Dismantle the lower garnish of Pillar
C.
a. Dismantle the tapping screw
under the shield.
b. Dismantle the tapping screw
inside the plug of storing box.
c. Remove the cage plate of back
door, and dismantle the screw
underneath.
d. Remove the lower garnish of
Pillar C.
Position light
Backup light
Turning light
Braking light
Plug of Storing Box
Fixing point
Chery T11 Service Manual
Body and Accessories
-32-
(3) Dismantle the three fixing nut from
the reserved hole on the body.
(4) Unplug the taillamp.
(5) Pull out the taillamp gentlely.
(6) Install in the reversed sequence.
Torque:
Fixing nut of taillamp 5±1Nm
Q3 2005(3 pcs)
3) Bulb Replacement
(1) Open the plug cover of storing box at
rear luggage cabin.
(2) Prize up the internal protection cover
by screwdriver. Screw out the bulbs
for sidelamps, backup lamp, turning
lamp
and
stop
lamp
counterclockwisely by hand through
the hole.
(3) Replace them with new bulbs.
Fixing point
Chery T11 Service Manual
Body and Accessories
-33-
9. License Plate Lamp
ⅰ Removal and installation of license plate lamp
1) The lamp for license plate is attached to the
back bumper by its elastic clip seat at both
ends.
2) For dismantle, press the clip seat by flat
screwdriver, remove the lamp for license
plate slowly, and unplug the pluged in.
3) For installation, insert the pluged in, then
push the lamp for license plate in.
ⅱ Replacement of license plate lamp bulb
1) Screw off the bulb counterclockwisely
when the lamp for license plate is taken
out.
2) Replace it with new bulb.
10. Removal and Intallation of Side Turning Lamp
1) Hold the side turning lamp by hand and
pull back to remove the lamp slowly.
2) For installation, force it in reversed
direction to the place.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст