Chery A15 / 480 LHD model. Manual — part 127

DISASSEMBLY AND ASSEMBLY OF THE GEARSHIFT SHAFT OIL SEAL

——The disassembly and assembly of the

gearshift shaft oil seal can be done when the
transmission is not broke down.

Disassembly:

——See the picture, remove the oil seal by a flat

spade or punch.

Assembly:

——Lubricate the lip of oil seal and press oil seal

into transmission housing completely by a
special tool.

J-29

DISASSEMBLY AND ASSEMBLY OF THE GEARSHIFT SHAFT BEARING

Disassembly:
——It needs to take off the gearshift shaft and oil

seal as changing the gearshift shaft bearing.

——Penetrate the special tool into gearshift shaft

housing, see the picture, and tap it slightly
until the gearshift shaft out from the other
side.

Assembly:

——Assemble the bearing inside of the position

which can contain the gearshift shaft.

—— Press the bearing to its right position by

special tool and then assemble the gearshift
shaft.

J-30

Special Tool

Special Tool

Special Tool

DISASSEMBLY AND ASSEMBLY OF THE OUTPUT SHAFT NEEDLE BEARING

Disassembly:

——Remove the needle bearing by special tool,

see the picture.

Assembly:

——Press the needle bearing to its right position

by special tool.

J-31

Special Tool

DISASSEMBLY AND ASSEMBLY OF THE GEARSHIFT SHAFT

——It need not to break down the transmission

assembly.

Disassembly:

——Put transmission assembly on the shelf or

workbench.

— — Leave it on the neutral position. (The

gearshift shaft move smoothly on arrowhead
direction)

— —Screw off the gearshift positioning holder

assembly.

——Unscrew the bolt cover by special tool and

take off gearshift shaft.

——See the picture, press the spring holder to the

arrowhead direction to compress the internal
spring. Keep at this position until disassemble
the snap ring No.2.

Assembly:

——The assemble process is opposite to above

process.

Main point:

——Make sure the fork system on neutral gear.

——Moment to fasten bolt cover is 50Nm.

——Moment of fastening the gearshift shaft

positioning holder is 40Nm.

J-32