Chery QQ6 (S21) / S12LHD. Manual — part 138

4. Installation Steps

The installation steps are reverse to those for removal.

II. Removal, Installation & Maintenance of
Rear Bumper

1. Preparations

Tools: cross head screwdriver, flat head screwdriver, No.8 sleeve.
Spare parts: disposable clips.

2. Notes

2.1. Please wear necessary labor protection supplies to avoid
accidents.
2.2. Try to avoid scratching the painted surface of the bumper when
removing it.
2.3. When removing the bumper in colder environment, operate
gently to avoid damaging it.

3. Removal Steps

3.1 Disassemble the tail lights. (See Removal and Installation of Tail
Lights)
3.2. Open the trunk cover, and use a cross head screwdriver to
loosen off the four fixing clips on the rear bumper.





3.3. Use a cross head screwdriver to loosen off the three clips fixing
the rear bumper bottom and the vehicle body.
Note: Raise the vehicle with a hoister.






3.4 Use an 8# torque wrench to loosen the screws connecting the
wing sheet and the bumper.
Note: Two fixing screws on either side.

3.5 Pull off the connector of the rear license plate lights.








3.6 Disassemble the connector of the reverse radar and remove the
rear bumper assembly.








3.7 Unplug the reverse radar.








3.8 Use a cross head screwdriver to loosen the clip seat of the
reverse radar.

4. Installation Steps

The installation steps are reverse to those for removal.

松

紧

Chapter V Removal and Installation of Headlights, Fog Lights & Tail Lights

1. Preparations

Tools: 10# open-ended wrench, cross head screwdriver.

2. Notes

2.1. Please wear necessary labour protection supplies to avoid any
accidents.
2.2. Try to avoid scratching the painted surface of the bumper when
removing it.
2.3. When removing the bumper in colder environment, operate
gently to avoid cracking it.
2.4. When disassembling the headlights, violent operation may
damage their clips on the bumper, so operate properly.
2.5 Pay attention not to scratch the headlight surface when
disassembling and placing it.

3. Removal Steps of Headlights

3.1. First open the front hood.

3.2. Use a 10# open-ended wrench to loosen off the three fixing
screws of the right headlights on the front compartment member.

3.3. Hold the headlight with both hands and apply a forward force to
loosen off the right headlights.






3.4. Unplug the right headlights harness to take out the right
headlights assembly.








3.5. Turn open the the high beam headlight holder shield by hand.







3.6. Press down the bulb fixing clip by hand and turn the clip over to
take out the bulb.