Chery QQ6 (S21) / S12LHD. Manual — part 137

4.9. Tear off the anti-water plastic sheeting on the rear door.







4.10. Connect the battery, lower the window glass to a proper
position and loosen off the two screws that fix the glass, and then
carefully diassemble the glass.













4.11. Use a 10# wrench to loosen off the five screws that fix the
window up-down regulator and remove it.












4.12. Use a 10# sleeve wrench to loosen off the screw that fix the
handle outside the rear door and then remove it.

4.13. Use a cross head screwdriver to loosen off the three screws
that fix the rear door lock core and then remove it.






4.14. Use a 13# sleeve wrench to loosen off the four screws (at the
hinge) that fix the right-rear vehicle door and then remove it.

5. Installation Steps

The installation steps are reverse to those for removal.
Note: Removal of the left-rear door is similar to that of the right-rear
door.

Chapter IV Removal, Installation & Maintenance of Front/Rear

Bumper

I. Removal, Installation & Maintenance of
Front Bumper

1. Preparations

Tools: 8# wrench, 8#sleeve, cross head screwdriver, flat head
screwdriver
Spare parts: disposable clips

2. Notes

2.1. Please wear necessary labor protection supplies to avoid
accidents.
2.2. Try to avoid scratching the painted surface of the bumper during
the removal operation.
2.3. For removal in colder environment, operate gently to avoid
damaging the bumper.

3. Removal Steps

(Take the left side as an example)
3.1 Open the Front Hood.
3.2 Remove the headlights. (See Removal and Installation of
Headlights)
3.3 Use a cross head screwdriver to loosen off the four screws on the
grid fence.


3.4. Use a 8# sleeve wrench to loosen off the two bolts on the
bumper and the left wing sheet.
Torque: 11N·m






3.5. Use a cross head screwdriver to loosen off the 7 screws on the
bumper and the front compartment member.

3.6. Use a 8# sleeve wrench and a cross head screwdriver to loosen
off the screws and fixing screws below the mud fender and the
bumper.
Installation Torque: 2±0.5 Nm






3.7 Raise the vehicle with a hoister.
3.8. Use a cross head screwdriver and 8#sleeve to loosen off the
fixing bolts and the screws below the mud fenderand the bumper.
Installation Torque: 2±0.5N.m















3.9. Pull off the fog lights connector.








3.10. Remove the bumper.