Chery QQ6 (S21) / S12LHD. Manual — part 136

4.16. Use a 10# sleeve wrench to loosen off the two fixing screws
and remove the lock outside the door.













4.17. Use a cross head screwdriver to loosen off the three screws
fixing the lock core and remove it.





4.18. Use a 13# sleeve wrench to loosen off the four fixing screws at
the hinge that fixes the vehicle door, and then the vehicle door can
be disassembled.

5. Installation Steps

The installation steps are reverse to those for removal.
Note: The removal steps for the right-front door are the same as
those for the left-front door.

II. Removal & Installation of Rear Doors

1. System Constitution Diagram

2. Preparations

Tools: flat head screwdriver, cross head screwdriver, and 10# / 13# sleeve, wrench.

3. Notes

3.1. Please wear necessary labor protection supplies to avoid
accidents.
3.2. Disconnect the battery so as to avoid damaging the eletrical
equipment.
3.3. Take correct steps during removal and installation of glass to
avoid any damage.

4. Removal Steps

4.1. Disassemble the right-rear door weather strip. The fixing clip of
the vehicle door weather strip are “-” shaped, and when
disassembling it, press the weather strip downward, and then push
the weather strip to one side till you can see part of the clip. And go
on to push it to the opposite direction till another corner of it is
exposed. Don’t pull the weather strip vertically so as not to damage
the weather strip.




4.2. Use a cross head screwdriver to loosen off the four screws that
fix the shield inside the door.

4.3. Use a flat head screwdriver to pry off the plastic cover of the
screws that fix the handle inside the vehicle door.







4.4. Use a cross head screwdriver to loosen off the screws that
secure the handle inside the door, and then disassemble it.






4.5. Use a cross head screwdriver to loosen off the screws that
secure the handle inside the vehicle door, and then disassemble the
handle inside the door.






4.6. Disassemble the shield inside the door by hand.






4.7. Pull off the power window up-down switch connector.






4.8. Use a cross head screwdriver to remove the two fixing screws in
the mount that fixes the rear door handle cover.