Chery QQ6 (S21) / S12LHD. Manual — part 11
41
Chapter 4 Disassembly/Reassembly and Maintenance of
Front/Rear Bumper
I. Disassembly/Reassembly and Maintenance of Front Bumper
1. System Composition Diagram
2. Preparation
No.7 and No10 sleeve, cross head screwdriver and flat head screwdriver.
3. Precautions
3.1. Please wear necessary labor protection supplies to avoid accidents.
3.2. To prevent scratch the bumper surface paint.
3.3. Carry out the disassembly and assembly at low temperature environment, do not use big force,
otherwise the bumper will be broken.
Front/Rear Bumper
42
4. Removal Step
4.1 Open the front engine hood by hand.
4.2 Loosen the fixing bolts of front bumper
from the right and left sides of radiator cross
beam with a 10# sleeve. (The left side is taken
as an example)
Torque: 11N·m
4.3 Loosen the fixing bolts of front bumper
from the intermediate part of radiator cross
beam with a 10# sleeve.
Torque: 11N·m
4.4 Loosen two fixing bolts under the bumper
from the mud guard with a 7# sleeve.
Installation torque: 2±0.5 Nm
4.5. Unscrew mudguard fixing bolt beside the
bumper with No.7 sleeve.
Installation torque: 2±0.5N.m
43
4.6 Remove the fixing bolts of mud guard from
the side of bumper with a cross screwdriver.
4.7 Pull out the bumper from the fixed
mounting at the fender by hand.
4.8. Pull out fog lamp plug by hand, and take
out bumper assy.
4.9 Remove three screws applied to joint the
fog lamp and bumper with a cross screwdriver.
4.10 Remove the bumper body assy.
44
4.11 Loosen three fixing bolts and a fixing nut
used to secure the front bumper stiffening beam
with a 13# sleeve.
Torque: 25±3N.m
4.12 Loosen intake grille fixing screws from
both sides of bumper with a cross screwdriver.
5. Installation and Maintenance
5.1. The installing steps are reverse to those for
removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст