Chery QQ6 (S21) / S12LHD. Manual — part 13
49
2. Preparation
No.10 sleeve and No.7 open end wrench, cross
head screwdriver and flat head screwdriver.
3. Precautions
3.1 Please wear necessary labor protection
supplies to avoid accidents.
3.2 To prevent scratch the bumper surface
paint.
3.3. In case of disassembly/reassembly in the
low temperature environment, the force applied
can’t be big so as to avoid the breakage of the
bumper. Disconnect the control switch of
corresponding lamps, and remove the wire
connected to the battery.
3.4. When the headlamp is being removed, pay
more attention to its clips on the bumper. The
big force may damage the clips.
3.5 Pay attention to not scratch the headlamp
surface when disassemble and place.
4. Removal Step of Headlamp
4.1. Disassemble front bumper assy first. (See
disassembly/assembly of bumper)
4.2. Loosen headlamp two fixing bolts on
engine hood cross beam with No.10 sleeve.
Torque: 3.5±0.5N·m
50
4.3. Remove the fixing bolts under the
headlamp with a cross screwdriver.
Torque: 1.8±0.2N·m
4.4. Pull out the plug from the headlamp, and
then take off the headlamp assy.
4.5. Open the lamp holder clips by hand.
4.6. Pull out two harness connectors by hand.
4.7. Remove two fix screws with a cross
screwdriver.
51
4.8. Hold the bulb seat by hand, and take off the
bulb from the headlamp.
CAUTION: In case that the bulb is replaced,
DO NOT contact the bulb by hand, otherwise
the fingerprint remained on the bulb is heated
and volatilzes after the lamp lights, and then
deposits on the mirror surface, which may
result that the reflector darkens.
4.9. Screw off headlamp high beam seat cover.
4.10. Pull out two harness connectors by hand.
4.11. Remove two fix screws with a cross
screwdriver.
52
4.12. Hold the bulb seat by hand, and take off
the bulb from the headlamp.
CAUTION: In case that the bulb is replaced,
DO NOT contact the bulb by hand, otherwise
the fingerprint remained on the bulb is heated
and volatilzes after the lamp lights, and then
deposits on the mirror surface, which may
result that the reflector darkens.
5. Removal of Fog Lamp
5.1. Remove the bumper assy. Refer to
Disassembly of Bumper.
5.2. Pull out the plug of fog lamp.
5.3. Unscrew three fixing nuts from the fog
lamp with a cross screwdriver.
5.4 Take off the fog lamp assy.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст