Range Rover Body Repair Manual — part 31
CHASSIS AND BODY
49
REPAIR
PARCEL TRAY SUPPORT
Service repair no - 76.67.11
Remove
1. Release 2 squab catches and fold rear seats
forward.
2. Remove parcel tray.
3. Remove 3 studs securing parcel tray support.
Remove support.
Refit
4. Reverse removal procedure.
PARCEL TRAY SUPPORT TRIM
Service repair no - 76.67.12 - Right Hand
Service repair no - 76.67.21 - Left Hand
Remove
1. Remove parcel tray support.
See this section.
2. Remove ’D’ post lower trim.
3. Release tailgate aperture seal from support trim
flange.
4. Remove 3 trim studs.
LH Trim Only
5. Remove CD autochanger.
See ELECTRICAL,
Repair.
6. Remove 2 nuts and 2 bolts securing sub-woofer
assembly.
76
CHASSIS AND BODY
NEW RANGE ROVER
50
REPAIR
7. Disconnect multiplug from sub-woofer.
Both Trim Panels
8. Release 2 sprag clips securing support trim to
body.
9. Remove support trim panel.
10. LH Trim Only: Separate sub-woofer from trim
panel.
Refit
11. Reverse removal procedure.
A,B,D and E POST TRIMS
Remove
1. Remove aperture seal from appropriate area.
2. Remove retaining screws (’A’ post lower trims)
3. Remove seat belt top mounting (’B’ and ’D’ post
upper trims)
4. Release retaining clips, remove finisher.
Refit
5. Position finisher, secure with retaining clips and
screws.
6. Fit seat belt top mounting. Tighten to
25 Nm.
(18lbf. ft)
7. Secure aperture seal.
NOTE: Illustration 76M 7128 shows the
fixing method for the A, B, D and E post
trim finishers.
1. A post upper
2. A post lower left hand
3. A post lower right hand
4. B post upper
5. B post lower
6. D post upper
7. D post lower
8. E post
CHASSIS AND BODY
51
REPAIR
76
CHASSIS AND BODY
NEW RANGE ROVER
52
REPAIR
’E’ POST - EXTERIOR TRIM
Service repair no - 76.43.
Remove
1. Open upper tailgate.
2. Remove 3 screws securing trim to ’E’ post.
3. Remove trim.
Refit
4. Position trim to ’E’ post, engage slot beneath
special washer on tailgate strut ball joint and
engage channel to rear edge of quarter glass.
5. Secure trim with screws.
6. Close tailgate.
SEAT BELT - FRONT
Service repair no - 76.73.13
Remove
1. Remove lower ’B’ post finisher.
2. Remove cover and nut securing seat belt to
upper anchorage point.
3. Release seat belt guide from ’B’ post.
4. Move seat fully forwards.
5. Remove bolt cover. Release seat belt from lower
anchorage point on seat.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст