Range Rover. Manual — part 234
CHASSIS AND BODY
31
REPAIR
13. Release outer operating cable from latch
abutment.
14. Release inner cable from latch.
15. Remove latch from door.
Refit
16. Fit latch.
17. Fit inner operating cable to latch.
18. Fit outer operating cable to latch abutment.
19. Fit sill button operating rod to latch.
20. Align latch to door, tighten 3 screws.
21. Secure remote handle cable to door panel clip.
22. Fit sill button to operating rod.
23. Reconnect 2 latch motor multiplugs.
24. Fit outside handle operating rod to latch.
25. Fit retaining clip.
26. Fit private lock operating rod to latch.
27. Fit retaining clip.
28. Secure plastic sheet.
29. Fit front door trim casing.
See this section.
76
CHASSIS AND BODY
NEW RANGE ROVER
32
REPAIR
REMOTE CONTROL - FRONT DOOR
Service repair no - 76.37.31
Remove
1. Remove front door trim casing.
See this
section.
2. Release top rear corner of plastic sheet.
3. Pull remote handle out. Release inner cable from
remote handle.
4. Release remote handle.
5. Remove 2 screws securing remote handle.
6. Remove outer cable from housing.
7. Remove remote by sliding rearwards.
Refit
8. Reverse removal procedure.
OUTER WAIST SEAL - FRONT DOOR
Service repair no - 76.31.53
Remove
1. Remove screw securing rear edge of outer waist
seal.
2. Remove outer waist seal.
Refit
3. Reverse removal procedure.
CHASSIS AND BODY
33
REPAIR
OUTSIDE HANDLE - FRONT DOOR
Service repair no - 76.58.07
Remove
1. Remove front door trim casing.
See this
section.
2. Release rear half of plastic sheet.
3. Remove retaining clip, private lock to latch
operating rod, at latch end.
4. Remove control rod from latch and private lock.
5. Remove retaining clip, outside handle to latch
operating rod, at latch end.
6. Remove control rod from latch and outside
handle.
7. Remove bolt securing rear of outside handle.
8. Slide outside handle forwards. Pull handle out,
release rear of handle from door.
76
CHASSIS AND BODY
NEW RANGE ROVER
34
REPAIR
9. Remove handle from front fixing by pivoting rear
end of handle out.
10. Remove gasket from handle.
11. Remove rubber locking plate from door.
12. Remove plastic locking plate from door.
13. Remove screw securing mounting plate to door,
remove plate.
Refit
14. Clean handle and door mating faces.
15. Reverse removal procedure.
PLASTIC SHEET - FRONT DOOR
Service repair no - 76.34.26
Remove
1. Remove front door trim casing.
See this
section.
2. Remove 2 screws securing door outstation ECU.
3. Remove 2 screws securing speaker amplifier.
4. Remove 4 screws securing front door speaker.
5. Release speaker, disconnect multiplug.
6. Remove plastic sheet.
Refit
7. Reverse removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст