Range Rover. Manual — part 236
CHASSIS AND BODY
39
REPAIR
PLASTIC SHEET - REAR DOOR
Service repair no - 76.34.28
Remove
1. Remove rear door trim casing.
See this
section.
2. Remove speaker.
See ELECTRICAL, Repair.
3. Remove 2 screws securing amplifier to door.
4. Remove plastic sheet.
Refit
5. Reverse removal procedure.
OUTSIDE HANDLE - REAR DOOR
Service repair no - 76.58.02
Remove
1. Remove rear door trim casing.
See this
section.
2. Remove bolt securing handle.
3. Remove outside handle.
NOTE: Operate and pull handle outward,
pivoting at forward mounting point.
4. Remove gasket.
5. Remove locking plates.
6. Remove screw securing mounting plate, remove
plate.
76
CHASSIS AND BODY
NEW RANGE ROVER
40
REPAIR
Refit
7. Clean handle face on door.
8. Fit handle mounting plate, tighten screw.
9. Fit locking plates.
10. Fit gasket to handle, position handle, secure with
screw.
11. Refit door trim casing.
See this section.
LATCH - REAR DOOR
Service repair no - 76.37.13/70
Remove
1. Remove window lift motor/control unit assembly.
See ELECTRICAL, Repair.
2. Release door lock remote control cable from clip
on window lift panel.
3. Remove 2 studs securing latch to window lift
panel.
4. Disconnect outer cable from abutment bracket.
5. Release remote cable from latch.
6. Release sill button link rod from latch. Remove
latch.
Refit
7. Lubricate new latch.
8. Fit latch to sill button link rod.
9. Fit remote control cable to latch.
10. Fit latch to window lift panel, secure with 2
retaining studs.
11. Refit window lift motor/control unit assembly.
See ELECTRICAL, Repair.
CHASSIS AND BODY
41
REPAIR
FIXED QUARTER LIGHT - REAR DOOR
Service repair no - 76.31.31
Remove
1. Remove outer waist seal.
See this section.
2. Remove door trim casing.
See this section.
3. From inside release seal from frame. Remove
seal and glass assembly outwards.
4. Remove seal from glass.
Refit
5. Clean glass, seal and frame.
6. Fit seal to glass. Fit assembly to door frame. If
necessary use a draw string to locate rubber.
NOTE: The opening light seal fits over the
fixed glass seal.
7. Fit door trim casing.
See this section.
8. Fit outer waist seal.
See this section.
REMOTE CONTROL - REAR DOOR
Service repair no - 76.37.32
Remove
1. Remove rear door trim casing.
See this
section.
2. Release plastic sheet to clear remote.
3. Remove foam pad from under window lift switch
multiplug.
4. Disconnect switch multiplug.
5. Release inner cable from remote lever.
6. Remove 2 screws securing remote to window lift
control panel.
7. Release remote outer cable from remote
housing.
8. Remove remote control.
Refit
9. Reverse removal procedure.
76
CHASSIS AND BODY
NEW RANGE ROVER
42
REPAIR
GLASS CHANNEL - REAR DOOR
Service repair no - 76.31.17
Remove
1. Remove window lift motor/control panel
assembly.
See ELECTRICAL, Repair.
2. Remove 2 bolts securing channel to door and
remove channel.
Refit
3. Fit channel to door, secure with 2 bolts.
4. Refit window lift motor/control panel assembly.
See ELECTRICAL, Repair.
SEAL - REAR DOOR
Service repair no - 76.40.02
Remove
1. Open rear door.
2. Remove rear door carpet retainer.
3. Remove rear door aperture seal.
Refit
4. Fit rear door aperture seal.
5. Refit rear door carpet retainer.
6. Close rear door.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст