Range Rover. Manual — part 230
CHASSIS AND BODY
15
REPAIR
16. Remove fuse cover from driver’s seat base trim.
17. Remove screw and 2 trim studs, remove seat
base trim.
18. Release 4 sprag clips, remove driver’s side
carpet retainer.
19. Remove 2 scrivet fasteners securing lower
closing panel to passenger side of fascia.
20. Release closing panel, disconnect footwell lamp,
release diagnostic multiplug. Remove closing
panel.
21. Remove 4 bolts, remove fascia centre bracket.
76
CHASSIS AND BODY
NEW RANGE ROVER
16
REPAIR
22. Disconnect 4 multiplugs from Body Electrical
Control Module (BeCM)
23. Remove captive nut, remove earth wires from
stud at base of driver’s side ’A’ post.
24. Disconnect multiplugs at base of each ’A’ post.
25. Release BeCM harness from sill, route into
fascia to prevent fouling as fascia is removed.
26. Disconnect multiplugs and release vacuum hose
from brake and clutch switches.
27. Models with SRS only: Disconnect SRS
multiplug from main harness.
CHASSIS AND BODY
17
REPAIR
28. Disconnect multiplug from SRS control module,
route harness into fascia to prevent fouling as
fascia is removed.
29. Remove both front wheel arch liners.
See this
section.
30. Remove 2 scrivet fasteners securing air cleaner
baffle beneath LH wheel arch. Remove baffle.
31. Disconnect both SRS crash sensor multiplugs.
32. Remove 4 bolts securing battery tray and 2 bolts
securing air cleaner to valance.
76
CHASSIS AND BODY
NEW RANGE ROVER
18
REPAIR
33. Raise air cleaner and battery tray for access to
crash sensor harness clips.
34. Release clips securing each crash sensor
harness to valance. Release harness grommets
and feed both harnesses through valance into
wheel arches.
35. Release 3 clips securing each crash sensor
harness to underside of wheel arches.
36. Release harness grommets, feed harnesses
through bulkhead and route into fascia to
prevent fouling as fascia is removed.
37. Vehicles with air conditioning only: Discharge
air conditioning system.
See AIR
CONDITIONING, Adjustment.
38. Remove bolt securing pipe clamp to
Thermostatic Expansion Valve (TXV).
39. Release pipes from TXV and remove ’O’ rings.
Seal pipes and ports of TXV.
40. All models: Remove 4 tube bolts securing
fascia to scuttle panel.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст