Range Rover. Manual — part 242
CHASSIS AND BODY
63
REPAIR
REAR SEAT BELT - RIGHT HAND
Service repair no - 76.73.24
Remove
1. Remove parcel shelf support trim.
See this
section.
2. Remove ’D’ post lower trim.
3. Remove cover and nut securing seat belt to
upper anchorage point.
4. Remove bolt securing seat belt reel.
5. Remove seat belt reel.
6. Remove right hand rear seat.
See SEATS,
Repair.
7. Remove 3 screws securing squab hinge cover.
Remove cover.
8. Remove 2 bolts securing squab to cushion
assembly. Remove squab.
9. Release beaded edge of cushion cover from
seat pan flange. Remove cushion cover/foam
assembly.
76
CHASSIS AND BODY
NEW RANGE ROVER
64
REPAIR
CAUTION: Take care when releasing
cover/foam from belt anchorage finisher.
10. Remove 3 screws securing anchorage cover to
seat pan. Remove cover in 2 pieces.
11. Remove bolt securing stalk to seat pan. Remove
stalk. Collect 2 spacers and wave washer.
CHASSIS AND BODY
65
REPAIR
Refit
12. Fit stalk to seat pan. Secure with bolt, spacers
and wave washer. Tighten to
35 Nm. (26 lbf.ft)
13. Fit seat belt anchorage cover. Secure with
screws.
14. Fit cushion assembly to seat pan. Secure
beaded edge of cover to seat pan flange.
15. Fit stalk to squab hinge. Secure with bolt.
Tighten to
35 Nm. (26 lbf.ft)
16. Position seat squab to cushion assembly.
Secure with bolts. Tighten to
45 Nm. (33 lbf.ft)
17. Refit squab hinge cover. Secure with screws.
18. Refit rear seat assembly.
See SEATS, Repair.
19. Position belt to upper anchorage point. Secure
with nut. Tighten to
25 Nm. (18 lbf.ft). Fit
cover.
20. Position seat belt reel. Secure with bolt. Tighten
to
35 Nm. (26 lbf.ft)
21. Fit ’D’ post lower trim.
22. Fit parcel shelf support trim.
See this section.
76
CHASSIS AND BODY
NEW RANGE ROVER
66
REPAIR
SLIDING ROOF - ELECTRIC
Service repair no - 76.82.44
Remove
1. Remove headlining.
See this section.
2. Disconnect motor multiplug.
3. Disconnect sliding roof drain tubes.
4. Remove 8 bolts securing sliding roof.
5. With assistance, remove 2 remaining bolts.
Remove sliding roof.
6. Remove seal from sliding roof.
Refit
7. Ensure mating faces are clean.
8. Fit new seal to sliding roof.
9. With assistance, position sliding roof. Fit 2 bolts.
10. Fit remaining bolts.
11. Connect drain tubes. Secure with clips.
12. Connect motor multiplug.
13. Refit headlining.
See this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст