Frelander 2. Manual — part 53
Stage 1:
Stage 2:
2.
WARNING: Make sure that a new lower arm ball
joint nut is installed.
CAUTION: Make sure that the ball joint ball does
not rotate.
Torque: 100 Nm
2.
3.
CAUTION: Do not allow halfshafts to hang unsupported at
one end or joint damage will occur.
Fully insert the front halfshaft into the wheel knuckle.
3.
4. NOTE: This step requires the aid of another technician.
Release the tension from the spring and damper assembly and
remove the special tool.
4.
5. CAUTIONS:
Make sure that a new bolt is installed.
Make sure that the brake hose is not twisted and
is correctly located.
Install a new front halfshaft bolt.
Torque:
45 Nm
80°
5.
Install the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
6.
Lower the hood and secure the support struts with the clips.
7.
Install the plenum chamber panel.
Refer to:
Plenum Chamber
(412-01 Climate Control, Removal and
Installation).
8.
Front Suspension - Front Stabilizer Bar
Removal and Installation
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
• NOTE: Only use clean water as a lubricant for the bushing, if required.
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the front wheels and tires.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
Remove the driveshaft.
Refer to:
Driveshaft - Vehicles W ithout: Diesel Particulate Filter
(DPF)
(205-01 Driveshaft, Removal and Installation).
3.
Remove the catalytic converters.
Refer to:
Catalytic Converter
(309-00A Exhaust System - I6 3.2L
Petrol, Removal and Installation).
4.
5.
CAUTION: Make sure that the ball joint ball
does not rotate.
Disconnect both stabilizer bar links.
Torque: 60 Nm
Discard the nuts.
5.
6.
WARNING: Make sure that new nuts are
installed.
Tighten in the sequence shown.
Torque: 175 Nm
Repeat the above procedure for the other side.
6.
7. NOTE: Do not disassemble further if the component
is removed for access only.
Remove the stabilizer bar bushings.
7.
Installation
1.
CAUTION: Nuts and bolts must be tightened with the weight
of the vehicle on the suspension.
To install, reverse the removal procedure.
1.
Front Suspension - Front Stabilizer Bar Bushing
Removal and Installation
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the front wheels and tires.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
3.
4.
CAUTION: Make sure that the ball joint ball
does not rotate.
Disconnect both front stabilizer bar links from
the stabilizer bar.
Discard the nuts.
4.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст