Frelander 2. Manual — part 54
5.
WARNING: Make sure that new nuts are
installed.
Remove the stabilizer bar bushing.
5.
Installation
1.
WARNING: Make sure that new nuts are
installed.
Install the stabilizer bar bushings.
Torque: 175 Nm
1.
2.
WARNING: Make sure that new nuts are installed.
CAUTION: Make sure that the ball joint ball does not rotate.
Install the stabilizer link bar.
Torque: 60 Nm
2.
Install the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
3.
Install the wheels and tires.
4.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
Front Suspension - Front Stabilizer Bar Link
Removal and Installation
Removal
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the front wheel.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
3.
WARNING: Make sure that new nuts are
installed.
CAUTION: Use an Allen key to prevent the ball
joint rotating whilst removing the nut.
Torque: 60 Nm
3.
Installation
To install, reverse the removal procedure.
1.
Front Suspension - Wheel Knuckle
Removal and Installation
Special Tool(s)
204-159
Lever, Wheel Knuckle
204-619
G-Clamp
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
211-316
Separator, Ball Joint
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the plenum chamber panel.
Refer to:
Plenum Chamber
(412-01 Climate Control, Removal and
Installation).
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст