Frelander 2. Manual — part 221
Disconnect the oil level sensor electrical sensor.
5.
Release the crankcase vent oil separator drain tube.
6.
Remove the 4 transmission bolts.
7.
Remove the oil pan extension panel.
8.
Remove the oil level sensor.
9.
Remove the gasket.
10.
Installation
Install the oil level sensor.
Torque: 8 Nm
1.
For sealant specification, refer to the specifications section.
Refer to:
Specifications
(303-01B Engine - TD4 2.2L Diesel,
Specifications).
2.
Stage 1:
Stage 2:
Apply a bead of sealant, 3 mm diameter, to the area
indicated.
3.
Install the oil pan extension panel.
Torque:
10 Nm
16 Nm
4.
Install the transmission retaining bolts.
Torque: 47 Nm
5.
Connect the crankcase vent oil separator drain tube.
6.
Connect the oil level sensor electrical connector.
7.
Install the dipstick.
8.
Install the dipstick tube.
Torque: 10 Nm
9.
Install the oil pan.
Refer to:
Oil Pan
(303-01B Engine - TD4 2.2L Diesel, Removal and
Installation).
10.
Install the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
11.
Engine - TD4 2.2L Diesel - Flywheel
Removal and Installation
Removal
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
2.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
2.
Remove the pressure plate and clutch disc.
Refer to:
Clutch Disc and Pressure Plate
(308-01 Clutch, Removal
and Installation).
3.
4. NOTE: Restrain the flywheel.
4.
Installation
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст