Range Rover Classic. Manual — part 153
CHASSIS AND BODY
35
REPAIR
ASYMMETRIC SPLIT REAR SEAT
Service repair no - 76.70.38
Remove
1. Lift footwell carpet to access front hinge bolts.
2. Remove hinge bolts.
3. Fold seat fully forward.
4. Remove rear hinge bolts.
5. Remove seat from vehicle.
Refit
6. Reverse removal procedure. Ensure seat folds
and latches smoothly.
ASYMMETRIC SPLIT REAR SEAT - LOCKING
MECHANISM
Service repair no - 76.70.51
Remove
1. Depress release button and fold seat forward.
2. Unscrew and remove release button.
3. Remove two trim buttons securing trim cover.
4. Remove trim cover.
5. Remove three screws securing latch to tower.
One screw is accessed through hole in tower.
6. Retrieve latch from opening rear of tower.
7. Remove operating rod by releasing plastic clip.
76
CHASSIS AND BODY
36
REPAIR
Refit
8. Reverse removal procedure. When release
button is depressed there must be a gap from 5
to 8 mm between head of button and lip of trim
cover.
FRONT SEAT HEATED CUSHION AND SQUAB
Service repair no - 76.77.05 / 76.77.14
Remove heated cushion.
1. Remove front seat assembly.
See Front Seat
Electrical
2. Remove two screws securing seat control
adjustment unit.
3. Remove two screws securing corner trim.
4. Release seat belt buckle bracket.
5. Release trim from seat frame.
CHASSIS AND BODY
37
REPAIR
6. Disconnect heater wiring at multiplug to seat
squab. Remove cushion and trim from seat
frame.
7. Turn 90
°
two seat trim retention plates and push
through slot in cushion foam.
8. Fold seat trim over cushion to reveal stapled
wire retention rods.
9. Pry open staples and release seat trim from seat
cushion.
Continue for removal of heated squab.
10. Remove headrest.
11. Remove squab panel rear. Three screws at
base. Peel back trim to remove screw from each
top corner.
12. Remove armrest assembly.
13. Release trim from edge of seat frame.
14. Remove squab foam with trim from seat frame.
15. Turn 90
°
two trim retention plates and push
through slot in foam.
16. Fold trim over squab foam to reveal two wire
retention rods.
17. Pry open staples and release trim from squab
cushion.
Refit
18. Reverse removal procedure.
76
CHASSIS AND BODY
38
REPAIR
SEAT BELTS
Introduction
Seat belt assemblies are factory fitted. If removal is
necessary follow procedures in this section. All seat
belt fixings MUST be tightened to correct torque
values.
Seat belt assemblies MUST be replaced after they
have been subjected to loading such as in a collision.
A lamp warning is incorporated to alert user. The
warning lamp will illuminate for eight seconds when
ignition is switched on regardless of seat belt usage.
On American specification vehicles a audible warning
will sound with an high and low note from four to eight
seconds unless driver seat belt is fitted.
A lap belt is provided for occupant of the centre rear
seat.
FRONT SEAT BELT
Service repair no - 76.73.10
Remove
1. Move seat to access belt mountings.
2. Disconnect battery negative lead.
3. Remove seat side trim panel.
See Front seat
4. Remove bolt, plain washer and spacer from belt
to seat base.
5. Remove moulding from adjustable seat belt
mounting.
6. Remove nut and spacer securing seat belt to
’B’post.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст