Jeep Grand Cherokee WK. Manual — part 1611
41. Snap the steering column opening cover (2) lower
hinges onto the pins and roll cover up.
42. Seat the upper retaining clips fully.
43. Install the hush panel.
44. Connect the column electrical connectors.
45. Install the column covers.
23 - 102
INSTRUMENT PANEL
WK
46. Install the left a-pillar trim, the bolts and position
the door seal back.* Right a-piller trim shown, left
similar.
47. Position the left side end cap and seat fully.
48. Install the center support nut onto the stud.
WK
INSTRUMENT PANEL
23 - 103
49. Install the two HVAC bolts within the radio open-
ing.
50. Install the radio.
51. Install the radio bezel.
52. Install the left and right center support brackets
and nuts and tighten to 12 N·m (105 in. lbs.).* Left
side shown, right side similar.
53. Position the center wire harness and connect the
electrical connectors.
54. Install the center bezel.
55. Position the defroster vents (2) and seat fully.
23 - 104
INSTRUMENT PANEL
WK
56. Connect the center harness electrical connectors
(ground, module, shifter, brake lever).
57. Install the center floor duct (3).
58. Position the console (1) into the vehicle and install
the screws (2).
59. Connect the electrical connector (3) and install the
rear cover (2) onto the console (1).
WK
INSTRUMENT PANEL
23 - 105
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст