Jeep Grand Cherokee WK. Manual — part 1612
60. Position the shifter bezel and seat fully.
61. Position the shifter bezel trim ring and seat fully.
23 - 106
INSTRUMENT PANEL
WK
INTERIOR
TABLE OF CONTENTS
page
page
INTERIOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 107
A-PILLAR TRIM/GRAB HANDLE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 108
. . . . . . . . . . . . . . . . . . . . . . . . 108
ASSIST HANDLE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 108
. . . . . . . . . . . . . . . . . . . . . . . . 108
B-PILLAR LOWER TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 109
. . . . . . . . . . . . . . . . . . . . . . . . 110
B-PILLAR UPPER TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 112
. . . . . . . . . . . . . . . . . . . . . . . . 113
C-PILLAR UPPER TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 113
. . . . . . . . . . . . . . . . . . . . . . . . 113
CARPETS AND FLOOR MATS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 114
. . . . . . . . . . . . . . . . . . . . . . . . 114
COWL TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 115
. . . . . . . . . . . . . . . . . . . . . . . . 115
D-PILLAR TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 116
. . . . . . . . . . . . . . . . . . . . . . . . 117
DOOR SILL SCUFF PLATE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 118
. . . . . . . . . . . . . . . . . . . . . . . . 118
FLOOR CONSOLE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 119
. . . . . . . . . . . . . . . . . . . . . . . . 120
HEADLINER
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 122
. . . . . . . . . . . . . . . . . . . . . . . . 122
LIFTGATE OPENING UPPER TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 123
. . . . . . . . . . . . . . . . . . . . . . . . 123
LIFTGATE SCUFF PLATE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 124
. . . . . . . . . . . . . . . . . . . . . . . . 124
LOAD FLOOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 124
. . . . . . . . . . . . . . . . . . . . . . . . 124
QUARTER TRIM PANEL
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 125
. . . . . . . . . . . . . . . . . . . . . . . . 125
REAR VIEW MIRROR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 126
INSTALLATION - REAR VIEW MIRROR
INSTALLATION - REAR VIEW MIRROR
SUPPORT BRACKET . . . . . . . . . . . . . . . . . . 128
SUN VISOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 129
. . . . . . . . . . . . . . . . . . . . . . . . 129
SUN VISOR SUPPORT
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 129
. . . . . . . . . . . . . . . . . . . . . . . . 129
INTERIOR
CAUTION
CAUTION:: Do not attempt to remove interior trim panels or moldings without first removing the necessary
adjacent trim panels or moldings. To avoid damaging the trim panels, ensure that all the fasteners are
removed or disengaged before attempting to remove interior trim panels or moldings. Trim panels are
somewhat flexible but can be damaged if handled improperly.
WK
INTERIOR
23 - 107
A-PILLAR TRIM/GRAB HANDLE
REMOVAL
1. Using a small flat-bladed tool, carefully open the
two fastener covers located in the A-pillar trim
panel.
2. Remove the two bolts that secure the A-pillar trim
panel to the A-pillar and remove the trim panel.
INSTALLATION
1. Position the locating tabs of the A-pillar trim panel
into the slots located in the top of the instrument
panel.
2. Install the A-pillar trim panel onto the A-pillar and
install the two bolts. Tighten the bolts to 6 N·m (55
in. lbs.).
3. Close the two fastener covers located in the A-pillar
trim panel.
ASSIST HANDLE
REMOVAL
1. Pull the grab handle downward, remove the two screws that secure the grab handle to the roof panel, and
remove the grab handle from the headliner.
2. If equipped, disconnect the reading lamp wire harness connector.
INSTALLATION
1. If equipped, connect the reading lamp wire harness connector.
23 - 108
INTERIOR
WK
2. Position the grab handle on the headliner and install the two screws that secure the grab handle to the roof
panel. Tighten the screws to 2.2 N·m (20 in. lbs.).
B-PILLAR LOWER TRIM
REMOVAL
1. Adjust the front seat to its most forward position for
easiest access to the front seat belt lower anchor
cover (1) and the B-pillar trim.
2. Grasp the upper edge of the lower anchor cover
and pull upward to unsnap it from the front seat
cushion outboard side shield.
3. Remove the screw (2) that secures the lower
anchor to the outboard side of the front seat cush-
ion frame and position the seat belt out of the way.
4. Remove the front door sill scuff plate, (Refer to 23 - BODY/INTERIOR/DOOR SILL SCUFF PLATE - REMOVAL).
5. Remove the rear passenger door sill scuff plate, (Refer to 23 - BODY/INTERIOR/DOOR SILL SCUFF PLATE -
REMOVAL).
WK
INTERIOR
23 - 109
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст