Geely FC. Manual part — 46
Geely FC. Manual part - 46
Assemble a new clip spring on input shaft.
Assemble roller bearing, and assemble third and forth
ssynchronizer assemble by the direction in figure, at this time,
assemble forth gear on input shaft.
Assemble fixting ball liking that shown in figure, and assemble
fifth gear stop gasket in input shaft by this ball.
Transmission—Disassemble assembly
181
Assemble clip spring with same method.
Assemble roller bearing, fifth gear, fifth gear synchronous loop
with same method above.
Assemble synchronizer assembly with pressure machine by
the direction in figure.
Press radial ball bearing in with pressure machine.
Transmission—Disassemble assembly
182
Press a new clip spring in input shaft by the direction in figure.
Press front tapered bearing in output shaft with method in
figure.
Note: make sure the bearing inner ring has been put into
position.
Press rear tapered bearing in output shaft with method above.
Note: make sure the bearing inner ring has been put into
position.
Transmission—Disassemble assembly
183
Press shift cover oil seal in with the method in figure, and the
distance from oil seal end surface to oil seal hole end surface
is 2.0-2.5mm after pressing it in.
Press in the other oil seal liking that shown in figure, and the
distance from oil seal end surface to oil seal hole end surface
is 0-0.5mm after pressing it in.
Assemble the gasket on shift guide shaft, and assemble dust-
proof cover in shift guide shaft, then assemble them on shift
cover.
Press a new clip spring on shift reverse shaft liking that shown
in figure.
Transmission—Disassemble assembly
184
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст