Geely FC. Manual part — 47
Geely FC. Manual part - 47
Assemble two new fork shaft clip spring, and assemble inter-
locking pin in the position in figure.
Assemble two new fork shaft clip springs liking that shown in
figure.
Assemble first and second gear fork on fork shaft, and put
fork shaft in first and second gear cover, then assemble first
and second guide block, at the same time, tighten the bolts,
the torque is 16Nm.
Press elastic cylindrical pin in guide block liking that shown in
figure.
Transmission—Disassemble assembly
185
Assemble lubricating oil pipe liking that shown in figure.
Press a new fork shaft clip spring in third and forth gear fork
shaft liking that in figure.
Assemble reverse gear block and fork shaft clip spring liking
that shown in figure.
Assemble third and forth gear fork shaft in clutch shell body,
and assemble third and forth shift fork in gear cover slot and
tighten them.
Bolt torque is 16N•m
Transmission—Disassemble assembly
186
Assemble interlocking pin in reverse gear block liking that
shown in figure.
Assemble two connecting bolts on reverse gear swing arm
bracket liking that shown in figure, their torque is 17N•m, and
put the head of reverse gear block in corresponding hole of
reverse gear swing arm bracket.
Put the head of reverse gear swing arm in the slot between
those reverse gear shafts liking that shown in figure.
Assemble reverse gear fork, spring and fifth reverse gear guide
block on fifth reverse fork shaft, and put fifth reverse gear
pulling fork in fifth gear cover, then assemble them in clutch
shell.
Transmission—Disassemble assembly
187
Spread seal fastening glue on the bolts, and connect trans-
position swing lever and transposition swing lever shaft with
transposition cover with bolts, bolt torque is 16N•m
Assemble A gasket, spring, interlocking bracket and shift swing
lever on shift reverse shaft by the sequence in figure, then
press elastic cylindrical pin in the hole of shift swing lever, at
the same time, the distance from its end surface to hole should
be 0-0.5mm after pressing it in.
Press in a new clamp spring liking that shown in figure.
Take out oil with the method in figure, and assemble a new oil
seal in transmission shell body.
Transmission—Disassemble assembly
188
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст