Geely Emgrand X7. Manual part — 247
Geely Emgrand X7. Manual part - 247
2.13.8.9 Timing chain cover hood replacement
Dismantlement Procedure
Warning: Refer to "Warning on Battery Disconnection" and "Warning on Cooling System
maintenance" in "Warning and Precautions".
1. Disconnect the battery negative
electrode cable. Refer to 2.11.8.1
Battery Disconnection.
2. Exhaust engine coolant, Refer
to“2.8.8.1 displacement and
filling of coolant .”.
3. Dismantle the plastic shield of
engine. Refer to 2.13.8.1
Replacement of Plastic Shield of
Engine.
4. Refer to 2.10.8.3 "Replacement
of Ignition Coil" to dismantle the
ignition coil.
FE02-0142b
5. Refer to 2.13.8.2 "Replacement of Cylinder Hood Cover" to dismantle the cylinder hood
cover.
6. Refer to 2.13.8.3 "Replacement of Drive Belt" to dismantle the drive belt.
7. For dismantlement of drive belt tensioner, see "Replacement of Drive Belt Tensioner".
8. For dismantlement of the generator assembly, see "2.11.8.3 Replacement of Generator".
9. For dismantlement of the water pump, see "2.8.8.6 Replacement of Water Pump".
10. Dismantle the engine mounting. Refer to 2.13.8.7 Replacement of Engine Mount.
11. Dismantle mounting bolt of power steering oil pump.
Note: In the confined operating space, lower the jack to facilitate the operation.
12. Rotate crankshaft, to make the
timing mark of crankshaft belt
align with scale 0, as shown in
figure.
FE02-0135b
987
13. Make sure that timing marks of
air intake VVT chain wheel and
exhaust chain wheel are in
positions shown in figure, to
ensure that cylinder 1 is on upper
stop point position of
compression. If the position is
wrong, repeat step 12 until
timing marks of intake and
exhaust chain wheel are on
positions shown in figure, and
make marks on chain wheels
with marker pen.
Note: the exhaust chain wheel has
three position marks, the one with
two points of which faces upward.
The VVT chain wheel has three
position marks. The grooved side of
the aluminum body should face up.
During alignment with the marks,
the yellow chain section may not
coincide with the mark. During
dismantlement, make sure the timing
marks of two chain wheels are on the
upmost position and the single-point
mark on the chain wheel is on the
horizontal straight line!
1
2
3
4
5
6
7
8
记号
记号
记号
凹槽
正时链罩的表面
FE02-0143b
14. Use special tool GL301-020 to
dismantle crankshaft pulley.
GL301-020
FE02-0144b
Mark
Timing chain cover
surface
Groove
988
15. Dismantle timing chain bar
tensioner .
FE02-0145b
16. Dismantle 3 M8 tightening bolts
of timing chain cover.
FE02-0146b
17. Dismantle 9 M6 fixing bolt and
bolt cap of timing chain.
FE02-0147b
989
18. Insert pry bar into groove
position, and loosen timing chain
cover.
FE02-0148b
19. Remove the timing chain cover.
FEE02-0149b
Installation Procedure:
1. Clean the residual sealant on the
timing chain cover and cylinder.
FE02-0150b
990
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст