Geely Emgrand X7. Manual part — 246
Geely Emgrand X7. Manual part - 246
2. Install connecting bolt of upper
bracket of electric generator.
Torque :25Nm(Metric) 18 .
5lb-ft(English system)
3. Install drive belt tensioner.
4. Install the drive belt.
5. Install and tighten the bolt for
connecting the right engine
suspension with the engine.
Torque :45Nm(Metric) 33 .
3lb-ft(English system)
6. Remove the supporting jack.
7. Install the generator assembly.
8. Install the plastic shield of
engine.
9. Install battery negative cable .
NL02-0118b
983
2.13.8.8 Timing chain tensioner replacement
Dismantlement Procedure
Warning: Refer to "Warning on Battery Disconnection" in "Warning and Precautions"!
1. Disconnect the battery negative
electrode cable. Refer to 2.11.8.1
Battery Disconnection.
2. Dismantle the plastic shield of
engine. Refer to 2.13.8.1
Replacement of Plastic Shield of
Engine.
3. Refer to 2.10.8.3 "Replacement
of Ignition Coil" to dismantle the
ignition coil.
4. Refer to 2.13.8.2 "Replacement
of Cylinder Hood Cover" to
dismantle the cylinder hood
cover.
5. Rotate the crankshaft and make
sure the cylinder No.1 is at TDC
position.
Note: Crankshaft timing mark is
aligned with the timing chain cast
scale line "0".
FE02-0135b
6. As shown in the graphic, mark on
the intake and exhaust sprocket
timing with a marker and use a
special tool GL301-022 to fix the
timing chain and special tool
GL301-018 to fix the camshaft.
FE02-0136b
984
7. Dismantle the timing chain
tensioner assembly.
Note: At this time do not rotate the
crankshaft in order to prevent the
timing chain teeth rolling.
FE02-0037b
Installation Procedure:
1. Press timing chain tensioner pull
rod to keep the tensioner into
selft-lock condition as shown in
figure.
FE02-0138b
2. Install the timing chain shroud
tensioner and tighten the nuts.
Torque :29N . m(Metric)21 .
5lb-ft(English system)
FE02-0039b
Up
Enter
Pin
Hook
985
3. Counterclockwise
rotate
crankshaft pulley to unlock
self-locking device of tensioner
and pop push rod.
Note: the force should be uniform in
the rotation process; otherwise, the
timing chain may cause slip tooth!
FE02-0140b
4. Confirm the tensioner unlocked
and the tensioner guide is firmly
pressed by the handle.
Note: If not properly unlocked, use a
screwdriver to push tensioner in the
opposite direction to unlock the
guide.
5. Install the cylinder hood cover.
6. Install the ignition coil.
7. Install the engine hood.
8. Connect battery negative cable.
FE02-0141b
986
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст