Geely Emgrand X7. Manual part — 244
Geely Emgrand X7. Manual part - 244
2.13.8.5 Replacement of Throttle Body Assembly
Dismantlement Procedure
Warning: Refer to "Warning on Battery Disconnection" in "Warning and Precautions".
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 Battery
Cable Disconnection/Connection
Procedures.
2. Dismantle the throttle pull cable.
3. Disconnect throttle control valve
harness connector.
NL02-0098b
4. Dismantle 2 fixing bolts and 2
nuts of throttle body and upper
fixing nut of throttle body
bracket.
NL02-0099b
5. Remove the electronic throttle
body from the intake manifold.
6. Clean the contact surface between
the engine throttle body and
intake manifold and replace with
new sealing ring.
NL02-0100b
975
Installation Procedure:
1. Install 2 fixing bolts and 2 fixing
nuts of throttle body and tighten
them.
Torque : 23Nm(Metric)
17lb-ft(English system)
NL02-0099b
2. Connect throttle control valve
wire harness connector.
3. Install air intake main pipe.
4. Connect the battery negative
cable .
NL02-0098b
976
2.13.8.6 Replacement of Intake Manifold Assembly
Dismantlement Procedure
1. Disconnect the battery negative
electrode cable. Refer to 2.11.8.1
Battery Disconnection.
2. Refer to 2.13.8.1 "Replacement
of Plastic Shield of Engine" to
dismantle the engine shied.
3. Refer to "Replacement of
Throttle Body Assembly" to
dismantle the throttle body.
4. Dismantle the forced ventilation
vacuum pipe of the crankcase.
FE02-0115b
5. Dismantle the canister solenoid
valve vacuum tube.
FE02-0116b
6. Dismantle the vacuum booster
vacuum tubes.
FE02-0117b
977
7. Dismantle the fixing bolts and
nuts of intake manifold in the
sequence as shown in the figure.
5
4
2
3
1
FE02-0118b
Installation Procedure:
1. Clean the cylinder head intake
manifold installation surface.
FE02-0119b
2. Clean the intake manifold
installation surface.
FE02-0120b
978
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст