Geely Emgrand X7. Manual part — 146
Geely Emgrand X7. Manual part - 146
8. Install the water outlet
components from heater
9.
Install the thermostat
components.
10. Install the water pump belt
pulley.
11. Install the drive belt.
12. Fill the engine coolant.
GC02-0098c
583
4G18engine :
Dismantlement Procedure
Warning: Refer to "Warning on Maintenance of Cooling System" in "Warnings and
Precautions".
1. Discharge engine coolant. Refer to 2.8.8.1 Engine Coolant Discharge and Filling.
2. Dismantle the drive belt. Refer to
2.6.8.3 Replacement of Drive
Belt.
3. Dismantle 2 short fixing bolt of
water pump.
NL02-0327b
4. Dismantle 4 long fixing bolts of
water pump.
NL02-0328b
5. Extract the water pump.
NL02-0329b
584
6. Take out seal ring of water pump.
NL02-0330b
Water Pump Inspection:
Warning: Refer to "Warning on
Protective Goggles" in "Warnings
and Precautions".
1. Inspect if water pump is broken
or leaks.
2. Inspect whether the water pump
bearing has a gap or abnormal
sound.
3. Inspect if water pump belt pulley
is damaged seriously. If it is
damaged, replace it.
NL02-0331b
Installation Procedure:
1. Clean water pump sealing ring
mounting groove and contact
surface.
NL02-0332b
585
2. Install new water pump seal ring.
Note: the seal ring is a single use
piece, which must be replaced by a
new one after disassembling at every
turn.
NL02-0333b
3. Install water pump and 4 fixing
bolts, but do not tighten them too
much.
4. Install 2 fixing bolts of water
pump, but do not tighten too
much.
5. Tighten fixing bolts of water
pump to the specified torque
according to the sequence as
shown in the figure .
Torque
Short mounting bolt of pump: 8Nm
(Metric) 6lb-ft (Inch)
Long mounting bolt of pump: 10Nm
(Metric) 7.4lb-ft (English system)
6. Install the drive belt.
7. Fill engine coolant.
2
4
6
3
1
5
NL02-0336b
586
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст