Geely Emgrand X7. Manual part — 145
Geely Emgrand X7. Manual part - 145
3. Install retaining nut of the engine
water inlet pipe joint
components.
Torque:10Nm(Metric) 7.4lb-ft(English
system)
NL02-0318b
4. Install components from water
outlet pipe of radiator to engine
water inlet pipe joint.
5. Tighten the radiator outlet pipe
clamp.
6. Fill engine coolant.
NL02-0319b
579
2.8.8.5 Replacement of Water Pump
4G20/4G24engine :
Dismantlement Procedure
1. Disconnect the battery negative
electrode cable. Refer to 2.12.6.1
Battery Disconnection.
2. Refer to 2.8.8.1 Engine Coolant
Discharge and Filling to
discharge engine coolant.
3. Dismantle the drive belt.
Refer to 2.6.8.3
Replacement of Drive Belt.
4. Refer to 2.8.8.4 "Replacement of
Thermostat" to dismantle the
thermostat component.
5. Dismantle the fixing bolts of
water pump belt pulley.
6. Remove the fixing bolt for the
water pump.
7. Dismantle the water pump belt
pulley.
GC02-0099c
8. Dismantle the fixing bolts of
water pump.
9. Dismantle the water pump
assembly.
GC02-0101c
580
10. Dismantle Heater Outlet Pipe
retaining screws.
11. Dismantle the Heater Outlet Pipe.
GC02-0098c
12. Dismantle the fixing bolts of
water pump housing.
13. Dismantle the water pump
housing.
GC02-0100c
Water Pump Inspection:
Warning: Refer to "Warning on
Safety Protective Eyewear" in
"Warning and Precautions".
1. Inspect whether the water pump
housing is cracking and leaking.
2. Inspect whether the water pump
bearing has a gap or abnormal
sound.
3. Inspect for the integrity of the
water pump belt pulley. If
the
water pump is damaged, replace
the whole set of the pump
housing subassembly.
GC02-0101c
581
Installation Procedure:
1. Clean the water pump housing
O-ring mounting groove and
mating surface.
2. Install the drainage valve.
3. Install the pump assembly to the
pump housing and tighten the
fixing bolts.
4. Install the inlet seats for the
thermostat and the engine.
GC02-0102c
5. Install new water pump housing
O-ring.
Note: The water pump housing
O-ring is a single used part and must
be replaced with new parts after
removal.
GC02-0103c
6. Install the water pump housing
subassembly and five mounting
bolts, but do not tighten at this
stage.
7. Tighten the fixing bolts of water
pump according to the sequence
as shown in the figure.
Torque: 32-38 N.m (Metric) 23.6-28.0
lb-ft (English system)
1
5
3
2
4
GC02-0104c
582
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст