Geely Emgrand X7. Manual part — 256
Geely Emgrand X7. Manual part - 256
2.13.8.15 Cylinder Hood Assembly Disassembly and Assembly
Dismantlement Procedure
1. Refer to 2.13.8.14 “Replacement
of Cylinder Hood Assembly” to
dismantle the cylinder hood
assembly.
2. Dismantle the valve Lifter.
FE02-0204b
3. Use a special tool to compress
the valve springs.
FE02-0205b
4. Remove the valve locking plate
with a magnetic stick.
FE02-0206b
1023
5. Remove the special tools and
remove the valve spring seat.
FE02-0207b
6. Remove the valve spring.
FE02-0208b
7. Remove the valve spring pads
with a magnetic stick.
FE02-0209b
1024
8. Dismantle the valve, mark the
original position of the valve in
order to re-install.
FE02-0210b
9. Dismantle the valve seals with
the special tool GL301-006.
FE02-0211b
Cleaning for check:
1. Clean the contacting surface with
the cylinder gasket.
2. Clean the mating surface with the
cylinder hood cover.
3. Inspect and confirm that the
cylinder hood and cylinder seal
gasket contacting surface has no
scratches.
4. Inspect and confirm that the
cylinder seal gasket contacting
surface has no leakage or
channeling gas.
5. Inspect whether there are cracks
on the cylinder hood.
6. Refer to 2.13.1.2 "Engine
Mechanical System
Specification" to measure the
height of the cylinder hood
within the measurement
FE02-0212b
1025
allowance. If the height is lower
than the standard value, replace
the cylinder hood.
Standard value :114 . 95mm/4 .
5281in
7. Inspect and confirm that the
sealing surface has no distortion
and warping and the cylinder
hood sealing surface flatness
must be within 0.05 mm (0.002
in).
8. Inspect and confirm that valve
seat ring has no excessive wear
and burnt places.
FE02-0213b
Installation Procedure:
1. Use a special tool to install
GL301-009 valve guide.
FE02-0502b
2. Use a special tool GL301-008 to
install the special valve seals.
FE02-0214b
1026
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст