Geely EC718, EC718RV, EC715, EC715RV. Manual part — 408
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 408
FE11-0286b
5.
Hold down the license plate tongue and remove the
license plate lamp.
6.
Remove the license plate lamp bulb.
Installation Procedure:
FE11-0287b
1.
Install the license plate lamp bulb.
Note
Avoid touching the bulb or letting the bulb to come
into contact with any moist. When the lamp is turned
on, the grease or moisture on the bulb may cause
the bulb explode. If the bulb contacts with grease or
moisture, clean the bulb with alcohol or an
appropriate cleaning agent and dry the bulb.
2.
Press the license plate lamp into the mounting hole on the
rear compartment lid.
3.
Install the rear compartment lid applique.
FE11-0288b
4.
Connect the license plate lamp harness connector.
5.
Install the rear compartment lid trim panel.
6.
Connect the battery negative cable.
Body Electric
Lighting System
11-145
11.4.8.15 Door Lamp Replacement
Removal Procedure
FE11-0289b
1.
Remove the door lamp cover.
FE11-0290b
2.
Remove the door lamp bulb.
Installation Procedure:
FE11-0291b
1.
Install the door lamp bulb.
Note
Avoid touching the bulb or letting the bulb to come
into contact with any moist. When the lamp is turned
on, the grease or moisture on the bulb may cause
the bulb explode. If the bulb contacts with grease or
moisture, clean the bulb with alcohol or an
appropriate cleaning agent and dry the bulb.
11-146
Lighting System
Body Electric
FE11-0292b
2.
Install the door lamp cover.
11.4.8.16 Reverse Switch Replacement
Removal Procedure
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
2
1
FE11-0293b
1.
Disconnect the battery negative cable. Refer to
.
2.
Disconnect the reverse switch wiring harness connector
(1).
3.
Remove the the reverse switch from the gearbox (2).
Body Electric
Lighting System
11-147
Installation Procedure:
1
2
FE11-0294b
1.
Install and tighten the reverse switch (1).
Torque: 40 Nm (Metric) 30 lb-ft (US English)
2.
Connect the reverse switch harness connector 2.
3.
Connect the battery negative cable.
11.4.8.17 Brake Lamp Switch Replacement
Removal Procedure
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
1
2
FE11-0295b
1.
Disconnect the battery negative cable. Refer to
.
2.
Disconnect the brake lamp switch wiring harness
connector (1).
3.
Release the locking nut, loose and remove the switch from
the brake pedal bracket (2).
11-148
Lighting System
Body Electric
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст