Geely EC718, EC718RV, EC715, EC715RV. Manual part — 255

FE03-0018b

8.

Remove the selector shaft self-locking bolt.

FE03-0019b

9.

Remove the four bolts as shown in the graphic.

FE03-0020b

10. Remove the shift control assembly.

Note

The gear must be at neutral position as shown in the
graphic, otherwise the shift control assembly is
unable to remove. During the removal, make sure
the return spring within the transmission is in a free
state, otherwise it may fall into the transmission
case.

Transmission / Drive Axle

Manual Transmission

3-63

Installation Procedure:

FE03-0021b

1.

Confirm the gear is at neutral position as shown in the
graphic.

FE03-0022b

2.

Install the return spring to the fixed hole and confirm it is
installed into place.

FE03-0023b

3.

Before installation, confirm the shift control assembly and
the control slider are at the same level.

3-64

Manual Transmission

Transmission / Drive Axle

FE03-0024b

4.

Before installation, apply sealant evenly on the mating
surface. Install the shift control assembly and tighten the
four retaining bolts.

FE03-0025b

5.

Install and tighten the selector shaft self-locking bolt.

FE03-0026b

6.

Install the selector shaft rod locating pin.

Transmission / Drive Axle

Manual Transmission

3-65

FE03-0027b

7.

Install the selector shaft rod retaining pin.

FE03-0028b

8.

Install the selector shaft rod locating pin.

FE03-0029b

9.

Install the selector shaft rod retaining pin.

3-66

Manual Transmission

Transmission / Drive Axle