Geely EC718, EC718RV, EC715, EC715RV. Manual part — 264
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 264
FE03-0128b
4.
Install the 1st and 2nd gear synchronizer snap ring.
FE03-0129b
5.
Install the 2nd gear needle bearing snap ring.
FE03-0130b
6.
Install the 2nd gear needle bearing.
Transmission / Drive Axle
Manual Transmission
3-99
FE03-0131b
7.
Install the 2nd gear.
FE03-0132b
8.
Install the 3rd gear with a special tool GL201-003.
Note
The 3rd gear need to be pressed into the position,
with the convex side up.
FE03-0133b
9.
Install the sleeve between the 3rd gear and the 4th gear.
3-100
Manual Transmission
Transmission / Drive Axle
FE03-0134b
10. Install the 4th gear with a special tool GL201-003.
Note
The 4th gear need to be pressed into the position,
with the convex side up.
FE03-0135b
11. Install the 5th gear with a special tool GL201-003.
Note
The 5th gear need to be pressed into the position,
with the convex side up.
FE03-0136b
12. Install the 5th gear snap ring.
Transmission / Drive Axle
Manual Transmission
3-101
FE03-0137b
13. Install the main shaft rear bearing with a special tool
GL201-007.
Note
If the bearings need to be replaced, the bearing
outer ring also need to be replaced. During the
removal, please use a special tool GL201-006. After
the installation of the transmission rear case, please
use a special tool GL201 - 008 to adjust the bearing
pre-load.
14. Install the main shaft assembly.
15. Install the shift shaft.
16. Install the shift control assembly.
17. Install the transmission.
3.3.8.9 Shift Lever Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
FE03-0138b
1.
Disconnect the battery negative cable.
.
2.
Remove the center console upper panel and Disconnect
the harness connector.
3-102
Manual Transmission
Transmission / Drive Axle
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст