Mazda 6. Manual — part 300
S–94
TRIM
5HB
1. Pull the trunk end trim upward, then disengage
clips A, pins B, and hooks.
2. Remove the trunk end trim.
3. Install in the reverse order of removal.
End Of Sie
LIFTGATE UPPER TRIM REMOVAL/INSTALLATION
A6E774468930W01
1. Pull the liftgate upper trim toward you, then
disengage clips A, and pin B from the body.
2. Remove the liftgate upper trim.
3. Install in the reverse order of removal.
End Of Sie
LIFTGATE SIDE TRIM REMOVAL/INSTALLATION
A6E774468940W01
1. Remove the liftgate upper trim.
2. Position the strap hanger as shown in the figure.
A6E7744W013
A6E7744W002
A6E7744W003
TRIM
S–95
S
3. Pull the liftgate side trim toward you, then
disengage clips A, pin B and the strap hanger
from the body and pin B, hook C, D from the
liftgate lower trim.
4. Remove the liftgate side trim.
5. Remove the hanger strap from the liftgate side
trim.
6. Install in the reverse order of removal.
End Of Sie
LIFTGATE LOWER TRIM REMOVAL/INSTALLATION
A6E774468960W01
1. Remove the liftgate upper trim.
2. Remove the liftgate side trim.
3. Pull the handle toward you, then remove the
handle.
4. Pull the liftgate lower trim toward you, then
disengage clips A, B and pins C, D from the body.
5. Remove the liftgate lower trim.
6. Install in the reverse order of removal.
End Of Sie
A6E7744W004
A6E7744W001
S–96
HEADLINER
HEADLINER REMOVAL/INSTALLATION
A6E774668030W01
1. Disconnect the negative battery cable.
2. Turn the seaming welt and weatherstrip over.
3. Remove the sunroof seaming welt. (vehicles with sunroof only)
4. Remove the A-pillar trims.
5. Remove the B-pillar upper trims.
6. Remove the C-pillar trims.
7. Remove the front and rear map light. (See
T–48 FRONT MAP LIGHT REMOVAL/INSTALLATION
.)
T–49 REAR MAP LIGHT REMOVAL/INSTALLATION
8. Remove the sunvisors.
9. Remove the assist handle.
10. Disconnect the roof harness connector, remove the clip, and remove the connector.
11. Remove the fasteners.
12. Disconnect the front and rear drain hose.
13. Disconnect the rear washer hose (5HB).
14. Remove the hook holding the roof panel and remove the headliner.
15. Take the headliner off from the passenger-side door opening.
16. Install in the reverse order of removal.
End Of Sie
HEADLINER
A6E7746W004
HEADLINER
S–97
S
SHOCK ABSORBING PAD REMOVAL/INSTALLATION
A6E774668H10W01
1. Remove the headliner.
2. Remove the fastener, then remove the shock
absorbing pad.
3. Install in the reverse order of removal.
End Of Sie
ASSIST HANDLE REMOVAL/INSTALLATION
A6E774669440W01
1. Insert a screwdriver into the assist handle notch
and remove the assist handle cover.
2. Pull the assist handle forward you, then remove
the assist handle.
3. Install in the reverse order of removal.
End Of Sie
A6E7746W003
A6E7746W001
A6E7746W002
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст