Mazda Protege 5. Manual — part 261
AUTOMATIC TRANSAXLE SHIFT MECHANISM
05–18–6
Selector Cable Installation Note
Caution
••••
Do not apply load to the manual shaft after manual shaft is shifted to P position. Otherwise, the
transaxle may be damaged.
1. Turn the manual shaft to the converter housing
side fully, to set the P position.
2. Install the selector cable to the selector lever.
Caution
••••
Bending the selector cable in the manner
shown in the figure will damage the cable
and it may become loose when shifted.
When installing the selector cable, hold it
straight.
3. Install the clip as shown in the figure.
X3U518WAD
X3U518WAE
X3U518WAF
X3U518WAQ
1712-1U-01G(05-18).fm 6 ページ 2001年6月29日 金曜日 午前10時14分
AUTOMATIC TRANSAXLE SHIFT MECHANISM
05–18–7
05–18
Note
•
Install the selector cable to the manual shaft
lever with the spring side of the selector
cable end facing the front of the vehicle.
4. Install the selector cable to the manual shaft lever
in such a way that the selector cable does not
bear a load.
5. Confirm that the end of the manual shaft lever
sticks out of the end of the selector cable.
6. Install the selector cable to the cable bracket.
7. Verify that the selector lever is at P position.
8. Unlock the lock piece of the selector cable
(selector lever side) in the order shown in the
figure.
9. Shift the selector lever from P position to 1 range,
and make sure that there are no other
components in that area to interfere with the
lever.
End Of Sie
X3U518WAG
X3U518WAH
X3U518WAJ
1712-1U-01G(05-18).fm 7 ページ 2001年6月29日 金曜日 午前10時14分
AUTOMATIC TRANSAXLE SHIFT MECHANISM
05–18–8
SELECTOR LEVER DISASSEMBLY/ASSEMBLY
A3U051846102W04
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
.
Connector Disassembly Note
1. Insert a thin piece of metal from the terminal side
of the connector, and press down the terminal
locking tab.
2. Pull the terminal out of the connector.
X3U518WAK
1
Connector
(See 05–18–8 Connector Disassembly Note.)
2
Screw
3
Selector lever knob
4
Cover
5
Indicator panel
6
Selector illumination light
7
Cam
(See 05–18–9 Cam Assembly Note.)
8
Selector lever
X3U518WAL
1712-1U-01G(05-18).fm 8 ページ 2001年6月29日 金曜日 午前10時14分
AUTOMATIC TRANSAXLE SHIFT MECHANISM
05–18–9
05–18
Cam Assembly Note
1. Loosely install the cam to the push rod.
Note
•
Clearance can be reduced by turning the cam clockwise.
2. Adjust the clearance between the guide plate and
the guide pin by turning the cam.
3. Install the selector lever knob and verify that the
clearance is as specified.
•
If not, repeat from Step 2.
4. Remove the selector lever knob.
5. Apply grease to the cam as shown.
End Of Sie
X3U518WAM
X3U518WAN
1712-1U-01G(05-18).fm 9 ページ 2001年6月29日 金曜日 午前10時14分
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст