Mitsubishi L200. Manual — part 487
FENDER
BODY
42-8
FENDER
REMOVAL AND INSTALLATION
M1421001901543
Pre-removal and Post-installation Operation
• Front Splash Shield Removal and Installation (Refer to
• Front Deck Garnish Removal and Installation (Refer to
GROUP 51, Windshield Wiper ).
• Headlamp Assembly Removal and Installation (Refer to
GROUP 54A, Headlamp ).
• Front Overfender Removal and Installation <Vehicles with
wide fender> (Refer to GROUP 51, Overfender .)
• Front Bumper Support Bracket Removal and Installation
(Refer to GROUP 51, Front Bumper Assembly ).
AC501252
1
2
AB
Removal steps
<<
A
>> >>
A
<< 1. Side turn-signal lamp
2. Fender
FENDER
BODY
42-9
REMOVAL SERVICE POINT
<<A>> SIDE TURN-SIGNAL LAMP REMOVAL
AC500497
AC407202
AC502956
A
A
Claw
Fender
AB
: Front of vehicle
MB990784
Section A – A
Hook
Side turn-signal lamp
Insert the special tool ornament remover
(MB990784) as shown to compress the hook and
disengage the claw. Remove the side turn-signal
lamp.
INSTALLATION SERVICE POINT
>>A<< SIDE TURN-SIGNAL LAMP INSTALLATION
AC502957
AC407202
Hook
Fender
Claw
AB
: Front of vehicle
Engage the claw and the hook onto the fender to
install the side turn-signal lamp.
FUEL FILLER LID
BODY
42-10
FUEL FILLER LID
REMOVAL AND INSTALLATION <SINGLE CAB>
M1421002501098
AC509874
Fuel filler lid height and clearance adjustment
1
2
3
4
4
5
AB
Fuel filler lid removal steps
1.
Fuel filler lid assembly
2.
Fuel filler lid locking clip
Fuel filler lid lock release handle
removal
3.
Fuel filler lid lock release handle
Fuel filler lid lock release cable
removal steps
•
Rear splash shield (Refer to
4.
Fuel filler lid hook
•
Front scuff plate and rear pillar trim
(Refer to GROUP 52A, Interior Trim
.)
•
A/C cooling unit (Refer to GROUP
55A, Heater Unit and Cooling Unit
.)
5.
Fuel filler lid lock release cable
Fuel filler lid lock release cable
removal steps (Continued)
FUEL FILLER LID
BODY
42-11
REMOVAL AND INSTALLATION <CLUB CAB>
M1421002501106
AC509875
Fuel filler lid height and clearance adjustment
1
2
3
4
4
5
AB
Fuel filler lid removal steps
1.
Fuel filler lid assembly
2.
Fuel filler lid locking clip
Fuel filler lid lock release handle
removal
3.
Fuel filler lid lock release handle
Fuel filler lid lock release cable
removal steps
•
Rear splash shield (Refer to
4.
Fuel filler lid hook
•
Front scuff plate and quarter trim
lower (Refer to GROUP 52A,
Interior Trim .)
•
A/C cooling unit (Refer to GROUP
55A, Heater Unit and Cooling Unit
.)
5.
Fuel filler lid lock release cable
Fuel filler lid lock release cable
removal steps (Continued)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст