Mitsubishi Outlander XL. Manual — part 1026
REPAIR BRACKET PART NUMBER
Part name
Part number
Headlight (LH) bracket (LH-side
3-piece set)
8301A664
Headlight (RH) bracket (RH-side
3-piece set)
8301A722
HEADLIGHT AUTOMATIC LEVELING SYSTEM
ON-VEHICLE SERVICE
HEADLIGHT AUTOMATIC LEVELING MOTOR
DRIVE TEST
M15410900035USA0000010000
Required Special Tools:
⦆
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
⦆
MB991824: Vehicle Communication Interface (V.C.I.)
⦆
MB991827: M.U.T.-III USB Cable
⦆
MB991910: M.U.T.-III Main Harness A (Vehicles with
CAN communication system)
⦆
The leveling motor drive test of headlight leveling unit
must be performed with the vehicle at a standstill (When
a vehicle speed signal is input from the headlight
automatic leveling ECU, the leveling motor drive test
cannot be performed).
ZC500215
MB991529
0000
1.
Hook up the scan tool or ground terminal 1 of data link
connector.
2.
Turn the ignition switch to the ON position.
3.
Turn ON the headlight switch.
4.
Check that the headlight leveling operates downward for 3
seconds.
NOTE:
⦆
When the leveling of the headlight faces downward at the
time of drive test start, it stays as is.
⦆
Only one drive test is possible after the ignition switch is
turned to the ON position.
5.
Check that the headlight leveling operates upward for 3
seconds.
LIGHTING
54Ac-177
HEADLIGHT AUTOMATIC LEVELING SYSTEM
HEADLIGHT AUTOMATIC LEVELING-ECU
REMOVAL AND INSTALLATION
M15410900039USA0000010000
ZC601249AA000
1
4.5 ± 1.5 N·m
40 ± 13 in-lb
Removal Steps
·
Glove box assembly (Refer to GROUP
52A - Instrument Panel Assembly P.
52A-2.)
Removal Steps
1.
Headlight automatic leveling-ECU
54Ac-178
LIGHTING
HEADLIGHT AUTOMATIC LEVELING SYSTEM
HEIGHT SENSOR
REMOVAL AND INSTALLATION
M15410900037USA0000010000
FRONT HEIGHT SENSOR
ZC305462AA00
1
23 ± 6 N·m
17 ± 4 ft-lb
9.5 ± 2.5 N·m
84 ± 22 in-lb
2
Removal Steps
1.
Front height sensor
Removal Steps
2.
Front height sensor sub harness
LIGHTING
54Ac-179
HEADLIGHT AUTOMATIC LEVELING SYSTEM
REAR HEIGHT SENSOR
ZC601621AA00
1
8 ± 2 N·m
70 ± 17 in-lb
9.5 ± 2.5 N·m
84 ± 22 in-lb
2
Removal Steps
1.
Rear height sensor
Removal Steps
2.
Rear height sensor sub harness
INSPECTION
HEIGHT SENSOR CHECK
M15410900040USA0000010000
FRONT HEIGHT SENSOR CHECK
ZC3052200000
Harness
side
Sensor side
MB991658
1.
Disconnect the sensor connector and connect the special tool
test harness (MB991658) as shown.
2.
Turn the ignition switch to the ON position.
3.
Measure the voltage of sensor connector terminal No. 2.
54Ac-180
LIGHTING
HEADLIGHT AUTOMATIC LEVELING SYSTEM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст