Dodge Ram Truck 1500-2500-3500. Manual — part 75
REMOVAL
1. With vehicle in neutral, position vehicle on hoist.
2. Remove half shaft hub nut.
3. Remove brake caliper and rotor.
4. Position hydraulic jack under lower suspension arm
and raise jack to unload rebound bumper.
5. Remove lower shock absorber bolt.
6. Remove upper ball joint nut and seperate ball with
Remover 8677 (2).
7. Disengage inner C/V joint from axle shaft with two
pry bars between the C/V housing and axle
housing.
8. Tilt knuckle (1) out and push half shaft (3) out of
the knuckle.
9. Remove half shaft from vehicle.
INSTALLATION
1. Clean hub bearing bore, hub bearing mating sur-
face and half shaft splines.
2. Apply a light coating of grease to the front axle
shaft output splines.
3. Install half shaft (2) into the knuckle.
4. Install half shaft on axle shaft. Push firmly to
engage axle shaft snap ring into the inner C/V
housing.
5. Install upper ball joint into the knuckle.
6. Install upper ball joint nut and tighten to specifica-
tion.
7. Install lower shock absorber bolt and tighten to
specification.
8. Install brake rotor and caliper.
3 - 132
HALF SHAFT
DR/DH
9. Install half shaft hub nut and tighten to 251 N·m (185 ft. lbs.).
SPECIFICATIONS
HALF SHAFT
TORQUE SPECIFICATIONS
DESCRIPTION
N·m
Ft. Lbs.
In. Lbs.
Half Shaft Nut
251
185
-
DR/DH
HALF SHAFT
3 - 133
SPECIAL TOOLS
3 - 134
HALF SHAFT
DR/DH
CV JOINT-OUTER
REMOVAL
1. Clamp shaft in a vise (with soft jaws) and support
C/V joint.
CAUTION: Do not damage C/V housing or half
shaft.
2. Remove clamps (2) (4) with a cut-off wheel or
grinder.
3. Slide the boot down the shaft.
4. Remove lubricant to expose the C/V joint snap ring
(1).
5. Spread snap ring (1) and slide the joint off the
shaft.
6. Slide boot off the shaft and discard old boot.
7. Mark alignment marks (1) on the inner race/hub
(2), bearing cage (3) and housing with dabs of
paint.
DR/DH
HALF SHAFT
3 - 135
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст