Dodge Ram Truck 1500-2500-3500. Manual — part 73
8. Press one bearing cap from outboard side of the
link yoke, enough to grasp the cap with vise jaws.
9. Grasp protruding bearing cap with vise jaws and
tap link yoke with a mallet to remove bearing cap.
10. Flip assembly and repeat Step 6, Step 7, Step 8
and Step 9 to remove the opposite bearing cap.
3 - 124
PROPELLER SHAFT
DR/DH
11. Remove cross centering kit assembly and spring.
12. Press remaining bearing caps out the other end of
the link yoke.
ASSEMBLY
CAUTION: All alignment marks on the link yoke
and propeller shaft yoke must be aligned during
assembled.
1. Apply (EP) N.L.G.I. Grade 1 or 2 grease to inside
of yoke bores.
2. Fit cross into the propeller shaft yoke.
DR/DH
PROPELLER SHAFT
3 - 125
3. Place bearing cap over the trunnion and align cap
with the yoke bore. Keep needle bearings upright
in the bearing cap.
4. Press bearing cap into yoke bore enough to clear
snap ring groove and install snap-ring.
3 - 126
PROPELLER SHAFT
DR/DH
5. Flip propeller shaft yoke and install other bearing
cap onto the opposite trunnion and install a snap
ring.
6. Fit link yoke onto remaining trunnions and press
both bearing caps into place and install snap rings.
DR/DH
PROPELLER SHAFT
3 - 127
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст