Dodge Viper SRT-10 (ZB). Manual — part 354
TEST
ACTION
APPLICABILITY
3
Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between ground and the Driver Door Switch Mux circuit in
the BCM C3 connector.
Is the resistance below 10000.0 (10K) ohms?
All
Yes
→ Repair the Driver Door Switch Mux circuit for a partial short to
ground
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 4
4
Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between the Driver Door Switch Mux circuit and the Driver
Door Switch Return circuits in the BCM C2 and C3 connectors.
Is the resistance below 10000.0 (10K) ohms?
All
Yes
→ Repair the Driver Door Switch Mux circuit for a partial short to
the Driver Door Switch Return circuit.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
309
POWER DOOR LOCKS/RKE
DRIVER INTERIOR DOOR HANDLE SWITCH STUCK —
Continued
Symptom:
PASSENGER DOOR LOCK CIRCUIT SHORT TO GROUND
When Monitored and Set Condition:
PASSENGER DOOR LOCK CIRCUIT SHORT TO GROUND
When Monitored:
At all times when battery power is supplied to the Body Control
Module.
Set Condition:
When the BCM senses voltage on the passenger door switch mux circuit
below 0.7 volts for over 10 seconds.
POSSIBLE CAUSES
DTC PRESENT
PASSENGER DOOR SWITCH MUX CIRCUIT SHORT TO GROUND
PASSENGER DOOR LOCK SWITCH SHORT TO GROUND
PASSENGER INTERIOR DOOR HANDLE SWITCH SHORT TO GROUND
PASSENGER EXTERIOR DOOR HANDLE SWITCH SHORT TO GROUND
PASSENGER DOOR SWITCH MUX WIRE SHORT TO THE DRIVER DOOR SWITCH RETURN.
BODY CONTROL MODULE - PASSENGER DOOR SWITCH MUX CIRCUIT SHORT TO GROUND
TEST
ACTION
APPLICABILITY
1
NOTE: When this code is present, the VTSS indicator will stay on solid during the
arming process.
With the DRBIII
t, record and erase DTC’s.
Cycle the ignition switch from ON to OFF to ON.
With the DRBIII
t, read DTC’s.
Lower the passenger door window.
Remove the key and operate all the passenger door switches several times while
monitoring the DRBIII
t.
Wait 10 seconds.
Does the DRBIII
t display PASSENGER DOOR LOCK CIRCUIT SHORT TO
GROUND?
All
Yes
→ Go To 2
No
→ Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
2
Disconnect the Body Control Module C3 and C4 connectors.
Measure the resistance between ground and the Passenger Door Switch Mux circuit
in the BCM C3 connector.
Is the resistance below 300.0 ohms?
All
Yes
→ Repair the Passenger Door Switch Mux circuit for a short to
ground
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 3
310
POWER DOOR LOCKS/RKE
TEST
ACTION
APPLICABILITY
3
Disconnect the Body Control Module C3 and C4 connectors.
Measure the resistance between the Passenger Door Switch Mux circuit and the
Passenger Door Switch Return circuits in the BCM C3 and C5 connectors.
Is the resistance below 200.0 ohms?
All
Yes
→ Go To 4
No
→ Go To 8
4
Disconnect the Body Control Module C3 and C4 connectors.
Disconnect the Passenger Door Lock Switch connector.
Measure the resistance between the Passenger Door Switch Mux circuit and the
Passenger Door Switch Return circuit in the BCM C3 and C5 connectors.
Is the resistance below 200 ohms?
All
Yes
→ Go To 5
No
→ Replace the Passenger Door Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
5
Disconnect the Body Control Module C3 and C4 connectors.
Disconnect the Passenger Interior Door Handle Switch connector.
Measure the resistance between the Passenger Door Switch Mux circuit and the
Passenger Door Switch Return circuit in the BCM C3 and C5 connectors.
Is the resistance below 200 ohms?
All
Yes
→ Go To 6
No
→ Replace the Passenger Interior Door Handle Switch.
Perform BODY VERIFICATION TEST - VER 1.
6
Disconnect the Body Control Module C3 and C4 connectors.
Disconnect the Passenger Interior Door Handle Switch connector.
Measure the resistance between the Passenger Door Switch Mux circuit and the
Passenger Door Switch Return circuit in the BCM C3 and C5 connectors.
Is the resistance below 200 ohms?
All
Yes
→ Go To 7
No
→ Replace the Passenger Exterior Door Handle Switch.
Perform BODY VERIFICATION TEST - VER 1.
7
If there are no possible causes remaining, view repair.
All
Repair
Repair the Passenger Door Switch Mux wire for a short to the
Passenger Door Switch Return wire.
Perform BODY VERIFICATION TEST - VER 1.
8
If there are no possible causes remaining, view repair.
All
Repair
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
311
POWER DOOR LOCKS/RKE
PASSENGER DOOR LOCK CIRCUIT SHORT TO GROUND —
Continued
Symptom:
PASSENGER DOOR LOCK SWITCH STUCK
When Monitored and Set Condition:
PASSENGER DOOR LOCK SWITCH STUCK
When Monitored:
At all times when battery power is supplied to the Body Control
Module.
Set Condition:
When the BCM senses a lock or unlock input on the Passenger Door
Switch Mux circuit for over 10 seconds, this code will set.
POSSIBLE CAUSES
DTC PRESENT
PASSENGER DOOR LOCK SWITCH SHORTED
PASSENGER DOOR SWITCH MUX CIRCUIT SHORT TO GROUND
PASSENGER DOOR SWITCH MUX CIRCUIT SHORT TO PASSENGER DOOR SWITCH RETURN
BODY CONTROL MODULE - PASSENGER DOOR SWITCH MUX CIRCUIT SHORTED
TEST
ACTION
APPLICABILITY
1
NOTE: When this code is present, the VTSS indicator will stay on solid during the
arming process.
With the DRBIII
t, record and erase DTC’s.
Cycle the ignition switch from ON to OFF to ON.
With the DRBIII
t, read DTC’s.
Lower the driver door window.
Remove the key and operate the Passenger Door Lock/Unlock Switch several times
while monitoring the DRBIII
t.
Wait 10 seconds.
Does the DRBIII
t display PASSENGER DOOR LOCK SWITCH STUCK?
All
Yes
→ Go To 2
No
→ Check the switch for a binding condition and replace if necessary.
Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
2
Disconnect the Passenger Door Lock Switch connector.
With the DRBIII
t in Sensors, read the PASS DOOR ENTRY voltage.
Is the voltage above 4.75 volts?
All
No
→ Go To 3
Yes
→ Replace the Passenger Door Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
312
POWER DOOR LOCKS/RKE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст