Infiniti FX35 / FX45. Manual — part 72
AT-216
< SERVICE INFORMATION >
ON-VEHICLE SERVICE
6.
Remove snap ring from A/T assembly harness connector.
7.
Push A/T assembly harness connector.
CAUTION:
Be careful not to damage connector.
8.
Remove bracket (1) (VK45DE), clips (2), oil pan (3) and oil pan
gasket.
•
: Vehicle front
•
: Bolt (22)
• Drain plug (4)
9.
Check foreign materials in oil pan to help determine causes of
malfunction. If the ATF is very dark, smells burned, or contains
foreign particles, the frictional material (clutches, band) may
need replacement. A tacky film that will not wipe clean indicates
varnish build up. Varnish can cause valves, servo, and clutches
to stick and can inhibit pump pressure.
• If frictional material is detected, perform A/T fluid cooler
cleaning. Refer to
AT-13, "A/T Fluid Cooler Cleaning"
10. Remove magnets from oil pan.
SCIA5021E
SCIA5022E
SCIA8128E
SCIA5199E
SCIA5200E
ON-VEHICLE SERVICE
AT-217
< SERVICE INFORMATION >
D
E
F
G
H
I
J
K
L
M
A
B
AT
N
O
P
11. Disconnect A/T fluid temperature sensor 2 connector (1).
CAUTION:
Be careful not to damage connector.
12. Straighten terminal clips (
) to free terminal cord assembly and
A/T fluid temperature sensor 2 harness.
13. Disconnect revolution sensor connector.
CAUTION:
Be careful not to damage connector.
14. Straighten terminal clip to free revolution sensor harness.
15. Remove bolts A, B and C from control valve with TCM.
•
: Vehicle front
16. Remove control valve with TCM from transmission case.
CAUTION:
When removing, be careful with the manual valve notch and
manual plate height. Remove it vertically.
SCIA8069E
SCIA7524E
SCIA7525E
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA8074E
SCIA5142E
AT-218
< SERVICE INFORMATION >
ON-VEHICLE SERVICE
17. Remove A/T fluid temperature sensor 2 with bracket from con-
trol valve with TCM.
18. Remove bracket from A/T fluid temperature sensor 2.
19. Remove O-ring from A/T assembly harness connector.
20. Disconnect TCM connectors.
CAUTION:
Be careful not to damage connectors.
SCIA5301E
SCIA5264E
SCIA5155E
SCIA5447E
ON-VEHICLE SERVICE
AT-219
< SERVICE INFORMATION >
D
E
F
G
H
I
J
K
L
M
A
B
AT
N
O
P
21. Remove A/T assembly harness connector from control valve
with TCM using a flat-bladed screwdriver.
22. Disconnect TCM connector and park/neutral position switch
connector.
CAUTION:
Be careful not to damage connectors.
Installation
CAUTION:
After completing installation, check A/T fluid leakage and A/F fluid level. Refer to
.
1.
Connect TCM connector and park/neutral position switch con-
nector.
2.
Install A/T assembly harness connector from control valve with
TCM.
SCIA5448E
SCIA5449E
SCIA5449E
SCIA5450E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст