Infiniti G35 (V35). Manual — part 80
ASSEMBLY
AT-311
D
E
F
G
H
I
J
K
L
M
A
B
AT
b.
Measure dimension “L”.
c.
Calculate dimension “J”.
2.
Measure dimensions “M
1
” and “M
2
” and then calculate dimen-
sion “M”.
a.
Place bearing race and needle bearing on oil pump assembly.
b.
Measure dimension “M
1
”.
c.
Measure dimension “M
2
”.
“J”:
Distance between oil pump fitting surface of
transmission case and needle bearing mating
surface of front sun gear.
J = K – L
SCIA5352E
SCIA3125E
SCIA3124E
SCIA3126E
SCIA3127E
AT-312
ASSEMBLY
d.
Calculate dimension “M”.
3.
Adjust total end play “T
1
”.
●
Select proper thickness of bearing race so that total end play
is within specifications. Refer to “Parts Information” for bear-
ing race selection.
Assembly (2)
NCS000JD
1.
Install O-ring to oil pump assembly.
CAUTION:
●
Do not reuse O-ring.
●
Apply ATF to O-ring.
2.
Install bearing race to oil pump assembly.
CAUTION:
Apply petroleum jelly to bearing race.
“M”:
“M”: Distance between transmission case fit-
ting surface of oil pump and needle bearing on
oil pump.
M = M
1
– M
2
SCIA3125E
T
1
= J – M
Total end play “T
1
”
: Refer to
SCIA2810E
SCIA5172E
SCIA6529E
ASSEMBLY
AT-313
D
E
F
G
H
I
J
K
L
M
A
B
AT
3.
Install oil pump assembly in transmission case.
CAUTION:
Apply ATF to oil pump bearing.
4.
Apply recommended sealant (Genuine RTV Silicone Sealant or
equivalent. Refer to
GI-46, "Recommended Chemical Products
.) to oil pump assembly as shown in the figure.
CAUTION:
Completely remove all moisture, oil and old sealant, etc.
From the oil pump mounting bolts and oil pump mounting
bolt mounting surfaces.
5.
Tighten oil pump mounting bolts to specified torque. Refer to
CAUTION:
Apply ATF to oil pump bushing.
6.
Install O-ring to input clutch assembly.
CAUTION:
●
Do not reuse O-ring.
●
Apply ATF to O-ring.
7.
Install converter housing to transmission case. Tighten con-
verter housing bolts to the specified torque. Refer to
.
●
: Bolt (8)
CAUTION:
Do not reuse self-sealing bolt (2).
SCIA2811E
SCIA5321E
SCIA2300E
SCIA5011E
SCIA8029E
AT-314
ASSEMBLY
8.
Make sure that brake band does not close turbine revolution
sensor hole.
9.
Install control valve with TCM.
a.
Connect TCM connector and park/neutral position switch con-
nector.
b.
Install A/T assembly harness connector from control valve with
TCM.
c.
Connect TCM connectors.
SCIA5034E
SCIA5449E
SCIA5450E
SCIA5447E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст