Infiniti G35 (V35). Manual — part 77
ASSEMBLY
AT-299
D
E
F
G
H
I
J
K
L
M
A
B
AT
5.
Install manual plate (with parking rod) to manual shaft.
6.
Install retaining pin into the manual plate and manual shaft.
a.
Fit pinhole of the manual plate to pinhole of the manual shaft with a pin punch.
b.
Use a hammer to tap the retaining pin into the manual plate.
CAUTION:
●
Do not reuse retaining pin.
●
Drive retaining pin to 2
±
0.5 mm (0.08
±
0.020 in) over the
manual plate.
7.
Install retaining pin into the transmission case and manual shaft.
a.
Fit pinhole of the transmission case to pinhole of the manual shaft with a pin punch.
b.
Use a hammer to tap the retaining pin into the transmission
case.
CAUTION:
●
Do not reuse retaining pin.
●
Drive retaining pin to 5
±
1 mm (0.20
±
0.04 in) over the
transmission case.
8.
Install O-rings to servo assembly.
CAUTION:
●
Do not reuse O-rings.
●
Apply petroleum jelly to O-rings.
SCIA5715E
SCIA5297E
SCIA2427E
SCIA5719E
AT-300
ASSEMBLY
9.
Install return spring to servo assembly.
10. Install servo assembly in transmission case.
11. Using pair of snap ring pliers, install snap ring to transmission
case.
12. Install D-rings in reverse brake piston.
CAUTION:
●
Do not reuse D-rings.
●
Apply ATF to D-rings.
13. Install reverse brake piston in transmission case.
SCIA5717E
SCIA5679E
SCIA2333E
SCIA6330E
SCIA2325E
ASSEMBLY
AT-301
D
E
F
G
H
I
J
K
L
M
A
B
AT
14. Install needle bearing to drum support edge surface.
CAUTION:
●
Take care with the direction of needle bearing. Refer to
AT-262, "Locations of Adjusting Shims, Needle Bearings,
Thrust Washers and Snap Rings"
●
Apply petroleum jelly to needle bearing.
15. Install seal rings to drum support.
CAUTION:
●
Do not reuse seal rings.
●
Apply petroleum jelly to seal rings.
16. Install spring retainer and return spring in transmission case.
17. Set the SST on spring retainer and install snap ring (fixing spring
retainer) in transmission case while compressing return spring.
CAUTION:
Securely assemble them using a flat-bladed screwdriver so
that snap ring tension is slightly weak.
SCIA2796E
SCIA3333E
SCIA2324E
SCIA5877E
AT-302
ASSEMBLY
18. Install reverse brake drive plates, driven plates and dish plates
in transmission case.
CAUTION:
Take care with order of plates.
●
Snap ring (1)
●
Retaining plate (2)
●
Drive plate (3)
●
Driven plate (4)
●
Dish plate (5)
●
Drive plate/Driven plate: 6/6
19. Assemble N-spring.
20. Install reverse brake retaining plate in transmission case.
21. Install snap ring in transmission case.
22. Measure clearance between retaining plate and snap ring. If not
within specified clearance, select proper retaining plate. Refer to
“Parts Information” for retaining plate selection.
SCIA6949E
SCIA5249E
SCIA2439E
Specified clearance “A”:
Standard
: Refer to
SCIA3129E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст