Volkswagen Golf / Golf GTI / Jetta. Manual — part 207
24-82
Special tools, materials and
equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
Test requirements
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
VAS 5024 Assembly tool for
spring-type clips
Electrical Wiring Diagrams
Chilling spray (commercially
available)
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Components, checking
24-83
Test sequence
Note:
Only gold plated terminals may be used to
service the terminals in the Intake Air
Temperature (IAT) sensor.
- Connect VAG 1551 Scan tool (or VAG 1552).
Then switch ignition on and select Motronic
Engine Control Module (ECM) -J220- with
"Address word" 01. ((VAG 1551 and Motronic
Engine Control Module (ECM) -J220-,
connecting and selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -0- and -4- for "Display group
number 4" and confirm entry with -Q- button.
Read measured value block 4
1
2
3
4
Indicated on display: (1 to 4
display zones)
- Read intake air temperature value in display
zone 4.
Specification: approx. ambient temperature
Components, checking
24-84
If the specification is not obtained:
- Check according to following table:
Display
1)
Cause
Continuation of
check
Approx. -
37.0 C
Open circuit or
short to
positive
Page 24-86
Approx.
126.0 C
Short to Ground
(GND)
Page 24-88
1)
If a temperature is displayed which is below
the ambient air temperature of the sensor, check
sensor wiring for transfer resistance. Note when
doing this that sensor may be heated from
external sources, e.g. radiated heat when engine
is not running.
If the specification is obtained:
- Remove intake hose between Mass Air Flow
(MAF) sensor and Throttle Valve Control Module
-J338- (
Page 24-32
, item 16 ) using VAS
5024 assembly tool for spring-type clips.
- Note intake air temperature value in display
zone 4.
Components, checking
24-85
- Spray sensor (arrow) with
commercial chilling agent while
observing temperature value.
Temperature value must
decrease.
- Press
button.
- Press buttons -0- and -6- for
function "End output" and confirm
entry with -Q- button.
- Switch off ignition.
- Replace Mass Air Flow (MAF)
sensor -G70-
Page 24-30
,
item 6 .
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст