Volkswagen Golf / Golf GTI / Jetta. Manual — part 198
24-46
Test requirements
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, this must be
switched off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Fuel Pump (FP) relay -J17- must
be OK., checking:
Components, checking
24-47
Test sequence
- Connect VAG 1551 Scan tool (or VAG 1552)
and select engine electronics control module
with "Address word" 01. Engine must be running
at idle speed: ((VAG 1551 and Motronic Engine
Control Module (ECM) -J220-, connecting and
selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -4- and -1- for "Display group
number 41" and confirm entry with -Q- button.
Read measured value block 41
1
2
3
4
Indicated on display: (1 to 4
display zones)
- Check the status of the Oxygen Sensor (O2S)
heating in display zone 4: Display: Htg.aC.ON /
Htg.aC.OFF (alternating)
Components, checking
24-48
Note:
The Oxygen Sensor (O2S) heating may be
switched on or off depending on the operating
conditions of the engine, therefore the display in
display zone 4 may show "Htg.aC.ON" or
alternating from "Htg.aC.ON" to "Htg.aC.OFF".
- Press the
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with the -Q- button.
- Switch off ignition.
If the display does not indicate as described:
- Remove protective cover -arrows- and
disconnect 4-pin connector (black) -1- to Oxygen
Sensor (O2S) Behind Three Way Catalytic
Converter (TWC) -G130-.
Components, checking
24-49
Checking resistance
If the specification is not obtained:
If the specification is obtained:
- Check sensor heater wire
resistance at connector terminals
1 and 2 to Oxygen Sensor (O2S).
- Specification: 6,4 to 47,5
(at
room temperature).
- Replace Oxygen Sensor (O2S) 2,
Bank 1 after Three Way Catalytic
Converter (TWC) -G130-
Page
24-17
, item 18 .
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Erase learned values and adapt
Motronic Engine Control Module
(ECM) -J220- again
Page 24-
182
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст