Volkswagen Golf / Golf GTI / Jetta. Manual — part 206
24-78
If no wiring malfunction is detected:
- Check wiring for open circuit
between test box and 4-pin
connector referring to Electrical
Wiring Diagrams.
Terminal 3 and socket 93
Terminal 4 and socket 108
Wire resistance: max. 1.5
- Additionally check wiring for short
to one another, to vehicle Ground
(GND) and to battery positive.
Specification:
- Perform resistance measurement
on Engine Coolant Temperature
(ECT) sensor -G62- terminal C
(signal) and D (Ground).
Components, checking
24-79
Scale A shows resistance values for
temperature range 0 to 50 C and
scale B the values for temperature
range 50 to 100 C.
Examples:
If the specification is not obtained:
30 C is in range A and
corresponds to a resistance of
1.5 to 2.0 k
80 C is in range B and
corresponds to a resistance of
275 to 375
- Replace Engine Coolant
Temperature (ECT) sensor -G62-
/ Engine Coolant Temperature
(ECT) sensor -G2-
Page 24-
16
, item 14 .
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Components, checking
24-80
If there is no Diagnostic Trouble Code (DTC) in
the wiring and the resistance measurement
values are OK.:
- Replace Motronic Engine Control Module (ECM)
-J220-
Page 24-173
.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Components, checking
24-81
Intake Air Temperature (IAT) sensor
-G42-, checking
Note:
The Intake Air Temperature (IAT) sensor -
G42- is a component part of the Mass Air
Flow (MAF) sensor -G70- and cannot be
replaced individually.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст