Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 411
– Remove the clip -2-.
– Remove the bolts -3-.
– Fold up the coat hook -10- and remove the bolt -4-.
– Pull and hold the operating lever for the backrest remote re‐
lease -5-.
– Remove the bolt -6-.
– Loosen the luggage compartment side trim panel -1- near the
clips -9- from the body mounts using the Pry Lever - 80-200- .
Vehicles with Converter with Socket
– Loosen the leaf spring -2- from the cover -1-.
– Release the retaining tabs on the cover -1- for the socket with
converter -3-.
– Remove the socket with the converter -3- from the cover -1-.
Continuation for All Vehicles
– If equipped, disconnect the connectors and remove the lug‐
gage compartment side trim panel.
Installing
Note
♦
Check all the fasteners for damage and replace if necessary.
♦
Remove any remaining clips in the body mounting points using
the Omega Clip Tool - T40280- . To install, insert into the lug‐
gage compartment side trim panel.
♦
Make sure the luggage compartment side trim panel fits inside
the rear lid seal molding after it is installed.
Install in reverse order of removal.
Tightening Specifications
♦ Refer to
⇒ “6.3.2 Overview - Luggage Compartment Side Trim Panel,
6.13
Rear Lid Upper Trim Panel, Removing
and Installing
Special tools and workshop equipment required
♦ Wedge Set - T10383-
Removing
– Disengage the retaining cable for the rear shelf at the left and
right side window frames.
– Loosen the center window frame -2- with the Wedge Set -
T10383- from the mounts in the rear lid and the side trim
panels -3-.
– Remove the center window frame -2-.
– Loosen the side window frame -3- with the Wedge Set -
T10383- from the retainers in the rear lid and the lower trim
panel -1-.
– Remove the side window frame -3-.
Installing
Note
♦
Check all the fasteners for damage and replace if necessary.
♦
Remove any remaining clips in the rear lid mounting points
using the Omega Clip Tool - T40280- . To install, insert into
the window frame.
Install in reverse order of removal.
6.14
Rear Lid Lower Trim Panel, Removing
and Installing
Special tools and workshop equipment required
♦ Omega Clip Tool - T40280-
Removing
– Remove the rear lid upper trim panel. Refer to
⇒ “6.13 Rear Lid Upper Trim Panel, Removing and Installing”,
.
– Remove the emergency triangle.
– Remove the bolts -2-.
– Unclip the side access covers in the trim panel -3-.
– Reach into the trim panel access openings with hands.
– Loosen the trim panel -3- with a »jerky pulling motion« from
the rear lid mounts -1-.
– Make sure that the entire number of clips -4- is in the trim panel
-3-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст