Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 327
– Remove the mirror glass. Refer to
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
– Remove the screws -3- (quantity: 3) and remove the adjusting
unit -1- from the mirror base.
– Move the adjuster unit -1- to the side and disconnect the con‐
nector -2- in direction of -arrow-.
Installing
– Attach the connector -2- to the adjusting unit -1-.
– Mount the adjusting unit -1- on the mirror base and tighten the
screws -3- (quantity: 3).
– Install the mirror glass. Refer to
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
Tightening Specifications
♦ Refer to
⇒ “7.1 Overview - Exterior Rearview Mirror”, page 435
7.4.2
Mirror Adjuster, Removing and Instal‐
ling, Version B
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left adjusting unit with motor. The right side is iden‐
tical.
Removing
Removing
– Remove the mirror glass. Refer to
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
.
– Remove the screw -3- and remove the adjusting unit -1- from
the mirror base.
– Move the adjusting unit with the motor -1- to the side and dis‐
connect the connector -2-.
Installing
– Attach the connector -2- to the adjusting unit -1-.
– Mount the adjusting unit -1- on the mirror base and tighten the
screws -3- (quantity: 3).
– Install the mirror glass. Refer to
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
Tightening Specifications
♦ Refer to
⇒ “7.1 Overview - Exterior Rearview Mirror”, page 435
7.5
Mirror Cap, Removing and Installing
Note
The following describes the removal and installation of the left mirror cap. The right side is identical.
Removing
– Remove the mirror glass. Refer to
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
– Release the hooks in direction of -A arrows-.
– Remove the mirror cap -1- from the mirror base toward the rear
in the direction of -arrow B-.
Installing
– Position the mirror cap -1- and push on it until the hooks en‐
gage audibly.
– Install the mirror glass. Refer to
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
.
7.6
Mirror Trim, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left mirror trim. The right side is identical.
Removing
– Remove the mirror glass. Refer to
⇒ “7.3 Mirror Glass, Removing and Installing”, page 438
.
– Remove the mirror cap. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст